openocd_program.cfg

UART developing tutorial module with source codes a褌胁 hints.

#define our ports
telnet_port 4444
gdb_port 3333

#commands specific to the Olimex ARM-USB-OCD
interface ft2232
ft2232_device_desc "Olimex OpenOCD JTAG A"
ft2232_layout "olimex-jtag"
ft2232_vid_pid 0x15BA 0x0003
jtag_speed 2
jtag_nsrst_delay 200
jtag_ntrst_delay 200

#reset_config <signals> [combination] [trst_type] [srst_type]
reset_config srst_only srst_pulls_trst

#jtag_device <IR length> <IR capture> <IR mask> <IDCODE instruction>
jtag_device 4 0x1 0xf 0xe

#daemon_startup <'attach'|'reset'>
daemon_startup reset

#target <type> <endianess> <reset_mode> <jtag#> [variant]
target arm7tdmi little run_and_init 0 arm7tdmi_r4

#run_and_halt_time <target#> <time_in_ms>
run_and_halt_time 0 30

# commands below are specific to AT91sam7 Flash Programming
# ---------------------------------------------------------

#target_script specifies the flash programming script file
target_script 0 reset script.ocd

#working_area <target#> <address> <size> <'backup'|'nobackup'>
working_area 0 0x00200000 0x4000 nobackup

#flash bank at91sam7 0 0 0 0 <target#>
flash bank at91sam7 0 0 0 0 0