pickit2 - cadcam read-me.txt

来自「pickit2 schematic and firmware」· 文本 代码 · 共 52 行

LABCENTER PROTEUS TOOL INFORMATION FILE
=======================================

In case of difficulty, please e-mail [e-mail]

Tool set up for Proteus layout 'D:\PicKit2\Pickit2\PICKIT2.LYT'.
CADCAM generated at 10:10:44 on segunda-feira, 29 de janeiro de 2007.

File List
---------
Top Copper              : PICKIT2 - CADCAM Top Copper.TXT
Bottom Copper           : PICKIT2 - CADCAM Bottom Copper.TXT
Top Silk Screen         : PICKIT2 - CADCAM Top Silk Screen.TXT
Bottom Solder Resist    : PICKIT2 - CADCAM Bottom Solder Resist.TXT
Top SMT Paste Mask      : PICKIT2 - CADCAM Top SMT Paste Mask.TXT
Drill                   : PICKIT2 - CADCAM Drill.TXT

Photoplotter Setup
------------------
Format: RS274X, ASCII, 2.4, imperial, absolute, eob=*, LZO
Notes:  D=Diameter, S=Side, W=Width, H=Height

D10	CIRCLE	D=80th                                      FLASH
D11	CIRCLE	D=70th                                      FLASH
D12	DIL	W=100th               H=60th                FLASH
D13	DIL	W=60th                H=100th               FLASH
D14	CIRCLE	D=100th                                     FLASH
D15	SQUARE	S=80th                                      FLASH
D16	CIRCLE	D=8th                                       DRAW
D17	CIRCLE	D=15th                                      DRAW
D18	CIRCLE	D=12th                                      DRAW
D19	CIRCLE	D=10th                                      DRAW
D70	CIRCLE	D=20th                                      DRAW
D71	CIRCLE	D=2.5th                                     DRAW
D20	CIRCLE	D=90th                                      FLASH
D21	DIL	W=120th               H=80th                FLASH
D22	DIL	W=80th                H=120th               FLASH
D23	CIRCLE	D=130th                                     FLASH
D24	SMT	W=100th               H=100th               FLASH

NC Drill Setup
--------------
Format: ASCII, 2.4, imperial, absolute, eob=<CR><LF>, no zero suppression.
Notes:  Tool sizes are diameters. Layer sets are in brackets - 0=TOP, 15=BOTTOM, 1-14=INNER.

T01	30th (0-15)
T02	60th (0-15)
T03	40th (0-15)


[END OF FILE]