rfc1213-mib.txt

snmp based application it is used to get the info of snmp

    ::= { ip 17 }

ipFragFails OBJECT-TYPE
    SYNTAX  Counter
    ACCESS  read-only
    STATUS  mandatory
    DESCRIPTION
            "The number of IP datagrams that have been
            discarded because they needed to be fragmented at
            this entity but could not be, e.g., because their
            Don't Fragment flag was set."
    ::= { ip 18 }

ipFragCreates OBJECT-TYPE
    SYNTAX  Counter
    ACCESS  read-only
    STATUS  mandatory
    DESCRIPTION
            "The number of IP datagram fragments that have
            been generated as a result of fragmentation at
            this entity."
    ::= { ip 19 }

-- the IP address table

-- The IP address table contains this entity's IP addressing
-- information.

ipAddrTable OBJECT-TYPE
    SYNTAX  SEQUENCE OF IpAddrEntry
    ACCESS  not-accessible
    STATUS  mandatory
    DESCRIPTION
            "The table of addressing information relevant to
            this entity's IP addresses."
    ::= { ip 20 }

ipAddrEntry OBJECT-TYPE
    SYNTAX  IpAddrEntry
    ACCESS  not-accessible
    STATUS  mandatory
    DESCRIPTION
            "The addressing information for one of this
            entity's IP addresses."
    INDEX   { ipAdEntAddr }
    ::= { ipAddrTable 1 }

IpAddrEntry ::=
    SEQUENCE {
        ipAdEntAddr
            IpAddress,
        ipAdEntIfIndex
            INTEGER,
        ipAdEntNetMask
            IpAddress,
        ipAdEntBcastAddr
            INTEGER,
        ipAdEntReasmMaxSize
            INTEGER (0..65535)
    }

ipAdEntAddr OBJECT-TYPE
    SYNTAX  IpAddress
    ACCESS  read-only
    STATUS  mandatory
    DESCRIPTION
            "The IP address to which this entry's addressing
            information pertains."
    ::= { ipAddrEntry 1 }

ipAdEntIfIndex OBJECT-TYPE
    SYNTAX  INTEGER
    ACCESS  read-only
    STATUS  mandatory
    DESCRIPTION
            "The index value which uniquely identifies the
            interface to which this entry is applicable.  The
            interface identified by a particular value of this
            index is the same interface as identified by the
            same value of ifIndex."
    ::= { ipAddrEntry 2 }

ipAdEntNetMask OBJECT-TYPE
    SYNTAX  IpAddress
    ACCESS  read-only
    STATUS  mandatory
    DESCRIPTION
            "The subnet mask associated with the IP address of
            this entry.  The value of the mask is an IP
            address with all the network bits set to 1 and all
            the hosts bits set to 0."
    ::= { ipAddrEntry 3 }

ipAdEntBcastAddr OBJECT-TYPE
    SYNTAX  INTEGER
    ACCESS  read-only
    STATUS  mandatory
    DESCRIPTION
            "The value of the least-significant bit in the IP
            broadcast address used for sending datagrams on
            the (logical) interface associated with the IP
            address of this entry.  For example, when the
            Internet standard all-ones broadcast address is
            used, the value will be 1.  This value applies to
            both the subnet and network broadcasts addresses
            used by the entity on this (logical) interface."
    ::= { ipAddrEntry 4 }

ipAdEntReasmMaxSize OBJECT-TYPE
    SYNTAX  INTEGER (0..65535)
    ACCESS  read-only
    STATUS  mandatory
    DESCRIPTION
            "The size of the largest IP datagram which this
            entity can re-assemble from incoming IP fragmented
            datagrams received on this interface."
    ::= { ipAddrEntry 5 }

-- the IP routing table

-- The IP routing table contains an entry for each route
-- presently known to this entity.

ipRouteTable OBJECT-TYPE
    SYNTAX  SEQUENCE OF IpRouteEntry
    ACCESS  not-accessible
    STATUS  mandatory
    DESCRIPTION
            "This entity's IP Routing table."
    ::= { ip 21 }

ipRouteEntry OBJECT-TYPE
    SYNTAX  IpRouteEntry
    ACCESS  not-accessible
    STATUS  mandatory
    DESCRIPTION
            "A route to a particular destination."
    INDEX   { ipRouteDest }
    ::= { ipRouteTable 1 }

IpRouteEntry ::=
    SEQUENCE {
        ipRouteDest
            IpAddress,
        ipRouteIfIndex
            INTEGER,
        ipRouteMetric1
            INTEGER,
        ipRouteMetric2
            INTEGER,
        ipRouteMetric3
            INTEGER,
        ipRouteMetric4
            INTEGER,
        ipRouteNextHop
            IpAddress,
        ipRouteType
            INTEGER,
        ipRouteProto
            INTEGER,
        ipRouteAge
            INTEGER,
        ipRouteMask
            IpAddress,
        ipRouteMetric5
            INTEGER,
        ipRouteInfo
            OBJECT IDENTIFIER
    }

ipRouteDest OBJECT-TYPE
    SYNTAX  IpAddress
    ACCESS  read-write
    STATUS  mandatory
    DESCRIPTION
            "The destination IP address of this route.  An
            entry with a value of 0.0.0.0 is considered a
            default route.  Multiple routes to a single
            destination can appear in the table, but access to
            such multiple entries is dependent on the table-
            access mechanisms defined by the network
            management protocol in use."
    ::= { ipRouteEntry 1 }

ipRouteIfIndex OBJECT-TYPE
    SYNTAX  INTEGER
    ACCESS  read-write
    STATUS  mandatory
    DESCRIPTION
            "The index value which uniquely identifies the
            local interface through which the next hop of this
            route should be reached.  The interface identified
            by a particular value of this index is the same
            interface as identified by the same value of
            ifIndex."
    ::= { ipRouteEntry 2 }

ipRouteMetric1 OBJECT-TYPE
    SYNTAX  INTEGER
    ACCESS  read-write
    STATUS  mandatory
    DESCRIPTION
            "The primary routing metric for this route.  The
            semantics of this metric are determined by the
            routing-protocol specified in the route's
            ipRouteProto value.  If this metric is not used,
            its value should be set to -1."
    ::= { ipRouteEntry 3 }

ipRouteMetric2 OBJECT-TYPE
    SYNTAX  INTEGER
    ACCESS  read-write
    STATUS  mandatory
    DESCRIPTION
            "An alternate routing metric for this route.  The
            semantics of this metric are determined by the
            routing-protocol specified in the route's
            ipRouteProto value.  If this metric is not used,
            its value should be set to -1."
    ::= { ipRouteEntry 4 }

ipRouteMetric3 OBJECT-TYPE
    SYNTAX  INTEGER
    ACCESS  read-write
    STATUS  mandatory
    DESCRIPTION
            "An alternate routing metric for this route.  The
            semantics of this metric are determined by the
            routing-protocol specified in the route's
            ipRouteProto value.  If this metric is not used,
            its value should be set to -1."
    ::= { ipRouteEntry 5 }

ipRouteMetric4 OBJECT-TYPE
    SYNTAX  INTEGER
    ACCESS  read-write
    STATUS  mandatory
    DESCRIPTION
            "An alternate routing metric for this route.  The
            semantics of this metric are determined by the
            routing-protocol specified in the route's
            ipRouteProto value.  If this metric is not used,
            its value should be set to -1."
    ::= { ipRouteEntry 6 }

ipRouteNextHop OBJECT-TYPE
    SYNTAX  IpAddress
    ACCESS  read-write
    STATUS  mandatory
    DESCRIPTION
            "The IP address of the next hop of this route.
            (In the case of a route bound to an interface
            which is realized via a broadcast media, the value
            of this field is the agent's IP address on that
            interface.)"
    ::= { ipRouteEntry 7 }

ipRouteType OBJECT-TYPE
    SYNTAX  INTEGER {
                other(1),        -- none of the following

                invalid(2),      -- an invalidated route

                                 -- route to directly
                direct(3),       -- connected (sub-)network

                                 -- route to a non-local
                indirect(4)      -- host/network/sub-network
            }
    ACCESS  read-write
    STATUS  mandatory
    DESCRIPTION
            "The type of route.  Note that the values
            direct(3) and indirect(4) refer to the notion of
            direct and indirect routing in the IP
            architecture.

            Setting this object to the value invalid(2) has
            the effect of invalidating the corresponding entry
            in the ipRouteTable object.  That is, it
            effectively dissasociates the destination
            identified with said entry from the route
            identified with said entry.  It is an
            implementation-specific matter as to whether the
            agent removes an invalidated entry from the table.
            Accordingly, management stations must be prepared
            to receive tabular information from agents that
            corresponds to entries not currently in use.
            Proper interpretation of such entries requires
            examination of the relevant ipRouteType object."
    ::= { ipRouteEntry 8 }

ipRouteProto OBJECT-TYPE
    SYNTAX  INTEGER {
                other(1),       -- none of the following

                                -- non-protocol information,
                                -- e.g., manually configured
                local(2),       -- entries

                                -- set via a network
                netmgmt(3),     -- management protocol

                                -- obtained via ICMP,
                icmp(4),        -- e.g., Redirect

                                -- the remaining values are
                                -- all gateway routing
                                -- protocols
                egp(5),
                ggp(6),
                hello(7),
                rip(8),
                is-is(9),
                es-is(10),
                ciscoIgrp(11),
                bbnSpfIgp(12),
                ospf(13),
                bgp(14)
            }
    ACCESS  read-only
    STATUS  mandatory
    DESCRIPTION
            "The routing mechanism via which this route was
            learned.  Inclusion of values for gateway routing
            protocols is not intended to imply that hosts
            should support those protocols."
    ::= { ipRouteEntry 9 }

ipRouteAge OBJECT-TYPE
    SYNTAX  INTEGER
    ACCESS  read-write
    STATUS  mandatory
    DESCRIPTION
            "The number of seconds since this route was last
            updated or otherwise determined to be correct.
            Note that no semantics of `too old' can be implied
            except through knowledge of the routing protocol
            by which the route was learned."
    ::= { ipRouteEntry 10 }

ipRouteMask OBJECT-TYPE
    SYNTAX  IpAddress
    ACCESS  read-write
    STATUS  mandatory
    DESCRIPTION
            "Indicate the mask to be logical-ANDed with the
            destination address before being compared to the
            value in the ipRouteDest field.  For those systems
            that do not support arbitrary subnet masks, an
            agent constructs the value of the ipRouteMask by
            determining whether the value of the correspondent
            ipRouteDest field belong to a class-A, B, or C
            network, and then using one of:

                 mask           network
                 255.0.0.0      class-A
                 255.255.0.0    class-B
                 255.255.255.0  class-C

            If the value of the ipRouteDest is 0.0.0.0 (a
            default route), then the mask value is also
            0.0.0.0.  It should be noted that all IP routing
            subsystems implicitly use this mechanism."
    ::= { ipRouteEntry 11 }

ipRouteMetric5 OBJECT-TYPE
    SYNTAX  INTEGER
    ACCESS  read-write
    STATUS  mandatory
    DESCRIPTION
            "An alternate routing metric for this route.  The
            semantics of this metric are determined by the
            routing-protocol specified in the route's
            ipRouteProto value.  If this metric is not used,
            its value should be set to -1."
    ::= { ipRouteEntry 12 }

ipRouteInfo OBJECT-TYPE
    SYNTAX  OBJECT IDENTIFIER
    ACCESS  read-only
    STATUS  mandatory
    DESCRIPTION
            "A reference to MIB definitions specific to the
            particular routing protocol which is responsible
            for this route, as determined by the value
            specified in the route's ipRouteProto value.  If
            this information is not present, its value should
            be set to the OBJECT IDENTIFIER { 0 0 }, which is
            a syntatically valid object identifier, and any
            conformant implementation of ASN.1 and BER must be
            able to generate and recognize this value."
    ::= { ipRouteEntry 13 }

-- the IP Address Translation table

-- The IP address translation table contain the IpAddress to
-- `physical' address equivalences.  Some interfaces do not
-- use translation tables for determining address
-- equivalences (e.g., DDN-X.25 has an algorithmic method);
-- if all interfaces are of this type, then the Address
-- Translation table is empty, i.e., has zero entries.

ipNetToMediaTable OBJECT-TYPE
    SYNTAX  SEQUENCE OF IpNetToMediaEntry
    ACCESS  not-accessible
    STATUS  mandatory
    DESCRIPTION
            "The IP Address Translation table used for mapping
            from IP addresses to physical addresses."
    ::= { ip 22 }

ipNetToMediaEntry OBJECT-TYPE
    SYNTAX  IpNetToMediaEntry
    ACCESS  not-accessible
    STATUS  mandatory
    DESCRIPTION
            "Each entry contains one IpAddress to `physical'
            address equivalence."
    INDEX   { ipNetToMediaIfIndex,
              ipNetToMediaNetAddress }
    ::= { ipNetToMediaTable 1 }

IpNetToMediaEntry ::=
    SEQUENCE {
        ipNetToMediaIfIndex
            INTEGER,
        ipNetToMediaPhysAddress
            PhysAddress,
        ipNetToMediaNetAddress
            IpAddress,