msp430x54x_uscia0_spi_10.c

来自「MSP430F5XXX的sample code」· C语言 代码 · 共 62 行

//******************************************************************************
//   msp430FG5438 Demo - USCI_A0, SPI 3-Wire Slave Data Echo
//
//   Description: SPI slave talks to SPI master using 3-wire mode. Data received
//   from master is echoed back.  USCI RX ISR is used to handle communication,
//   CPU normally in LPM4.  Prior to initial data exchange, master pulses
//   slaves RST for complete reset.
//   ACLK = ~32.768kHz, MCLK = SMCLK = DCO ~ 1048kHz
//
//   Use with SPI Master Incremented Data code example.  If the slave is in
//   debug mode, the reset signal from the master will conflict with slave's
//   JTAG; to work around, use IAR's "Release JTAG on Go" on slave device.  If
//   breakpoints are set in slave RX ISR, master must stopped also to avoid
//   overrunning slave RXBUF.
//
//                   msp430FG5438
//                 -----------------
//             /|\|                 |
//              | |                 |
//              --|RST              |
//                |                 |
//                |             P3.4|-> Data Out (UCA0SIMO)
//                |                 |
//          LED <-|P1.0         P3.5|<- Data In (UCA0SOMI)
//                |                 |
//  Slave reset <-|P1.1         P3.0|-> Serial Clock Out (UCA0CLK)
//
//
//   M Smertneck
//   Texas Instruments Inc.
//   April 2008
//   Built with CCEv3.2 IAR Embedded Workbench Version: 3.42A
//******************************************************************************

#include <msp430x54x.h>


void main(void)
{
  volatile unsigned int i;

  WDTCTL = WDTPW+WDTHOLD;                   // Stop watchdog timer

  while(!(P3IN&0x01));                      // If clock sig from mstr stays low,
                                            // it is not yet in SPI mode
  P3SEL |= 0x31;                            // P3.5,4,0 option select
  UCA0CTL1 = UCSWRST;                       // **Put state machine in reset**
  UCA0CTL0 |= UCSYNC+UCCKPL+UCMSB;          //3-pin, 8-bit SPI master
  UCA0CTL1 &= ~UCSWRST;                     // **Initialize USCI state machine**
  UCA0IE |= UCRXIE;                         // Enable USCI_A0 RX interrupt

  _BIS_SR(LPM3_bits + GIE);                 // Enter LPM4, enable interrupts
}

// Echo character
#pragma vector=USCI_A0_VECTOR
__interrupt void USCIA0_ISR (void)
{
  while (!(SFRIFG1&UCTXIFG));               // USCI_A0 TX buffer ready?
  UCA0TXBUF = UCA0RXBUF;
}