hardcfg.h

2812 开发库

/*********************************************************************
AtFlash 相关宏定义以及硬件描述

**********************************************************************/
#define  READ_MEMPAGE       0x52  //Main Memory Page Read
#define  READ_BUFFER1       0x54  //Buffer1 Read
#define  READ_BUFFER2       0x56  //Buffer2 Read
#define  MEMP_BUFFER1       0x53  //Main Memory Page to Buffer 1 Transfer
#define  MEMP_BUFFER2       0x55  //Main Memory Page to Buffer 2 Transfer
#define  COMP_MEMBUF1       0x60  //Main Memory Page to Buffer 1 Compare
#define  COMP_MEMBUF2       0x61  //Main Memory Page to Buffer 2 Compare
#define  WRITEBUFFER1       0x84  //Buffer1 Write
#define  WRITEBUFFER2       0x87  //Buffer2 Write
#define  BUF1_MEMP_ER       0x83  //Buffer1 to Main Memory Page Program with Built-in Erase
#define  BUF2_MEMP_ER       0x86  //Buffer2 to Main Memory Page Program with Built-in Erase
#define  BUF1_MEMP_NE       0x88  //Buffer1 to Main Memory Page Program without Built-in Erase
#define  BUF2_MEMP_NE       0x89  //Buffer2 to Main Memory Page Program without Built-in Erase
#define  PAGE_ERASE         0x81  //Page Erase
#define  BLOCK_ERASE        0x50  //Block Erase
#define  MEMP_BUF1_PR       0x82  //Main Memory Page Program through Buffer 1
#define  MEMP_BUF2_PR       0x85  //Main Memory Page Program through Buffer 2
#define  AUTOREWRBUF1       0x58  //Auto Page Rewrite through Buffer 1
#define  AUTOREWRBUF2       0x59  //Auto Page Rewrite through Buffer 2
#define  STATUS_REG         0x57  //Status Register

/*****************************************************************
TLC2578 相关宏定义以及硬件描述
*****************************************************************/
#define WRITECFR 			0x0a				//WRITE CFR, the last 12 bits of SDI are written into CFR.
#define TEST1 				0x0b				//SELECT TEST, voltage = (REFP+REFM)/2
#define TEST1 				0x0c				//SELECT TEST, voltage = REFM
#define TEST1 				0x0d				//SELECT TEST, voltage = REFP (see Note 17)
#define FIFOREAD 			0x0e				//FIFO READ, FIFO contents is shown on SDO;
#define SETDEFAULT 		0x0f				//HARDWARE DEFAULT mode, CFR is loaded with 800h