artsetup.txt

Atheros AP Test with Agilent N4010A source code

#initial configuration options
5_CHANNEL_MHZ = 5220    #The initial channel for tests
2_4_CHANNEL_MHZ = 2412    #The initial channel for tests
#ALL_2G_CHANNELS = 1

#eeprom configuration
EEPROM_LOAD_OVERRIDE = 1   #set to 1 to override loading of eeprom calibration info
TURBO = 0	  #set to 1 to enable turbo mode
MODE = 0

#register configuration files, comment out line to use defaults
#LOG_FILE = artout.log
LOGGING = 0
LOAD_EAR = 0

RATE_MASK = 0x7fff
LINK_NUM_PACKETS = 10

EEP_FILE_DIR = ./

#BLANK_EEP_ID = 0x1031   #which subsytem ID to use for lookup if blank eeprom

DUT_CARD_SSID = 0x6011

APPLY_CTL = 0		#set to 1 to enable power limiting by specified CTL
CTL_VALUE = 0x10	#specify which CTL to apply when APPLY_CTL is set
DEBUG_INFO = 0		#set to see additional debug info (used for engineering debug

#		subsystemID, filename		
CFG_TABLE =     0x6022  ar6000_tb111ag.eep
CFG_TABLE =     0x6011  ar6000_sd11g.eep
CFG_TABLE =     0x6010  ar6000_sd10ag.eep

CFG_TABLE =     0xa034  ar5002ap_ap30ag_040.eep
CFG_TABLE =     0x1052  ar5005g_cb51g.eep
CFG_TABLE =     0x2052  ar5005g_mb51g.eep
CFG_TABLE =     0x1054  ar5005g_cb53g.eep
CFG_TABLE =     0x2054  ar5005g_mb53g.eep
CFG_TABLE =     0x1051  ar5005gs_cb51g.eep
CFG_TABLE =     0x2051  ar5005gs_mb51g.eep
CFG_TABLE =     0x1053  ar5005gs_cb53g.eep
CFG_TABLE =     0x2053  ar5005gs_mb53g.eep
CFG_TABLE =     0xb051  ar5005ug_ub51g.eep
CFG_TABLE =     0xb052  ar5005ux_ub52ag.eep
CFG_TABLE =     0x2062  ar5006xs_mb62ag.eep
CFG_TABLE =     0x1062  ar5006xs_cb62ag.eep
CFG_TABLE =     0x2063  ar5006x_mb62ag.eep
CFG_TABLE =     0x1063  ar5006x_cb62ag.eep
CFG_TABLE =     0xa051  ar5006apgs_ap51g.eep
CFG_TABLE =     0xa052  ar5006apg_ap51g.eep
CFG_TABLE =     0x3062  ar5006exs_xb62ag.eep
CFG_TABLE =     0x3063  ar5006ex_xb62ag.eep