config.in

SMDK2440 boot code, base on vivi

#
# Serial device configuration
#
# $Id: Config.in,v 1.8 2004/03/25 04:43:05 nandy Exp $
#
mainmenu_option next_comment
comment 'Serial Port'

bool 'Serial Port (UART) support' CONFIG_SERIAL

if [ "$CONFIG_SERIAL" = "y" ]; then
  int 'Default serial baudrate' CONFIG_SERIAL_DEFAULT_BAUDRATE 115200
  bool 'Support serial terminal' CONFIG_SERIAL_TERM
  if [ "$CONFIG_SERIAL_TERM" = "y" ]; then
    choice 'User interface' \
      "STANDARD	CONFIG_SERIAL_GETCMD_STD \
       EXTENDED	CONFIG_SERIAL_GETCMD_EXT"
    string ' Default prompt' CONFIG_SERIAL_TERM_PROMPT "vivi"
    bool '  Blank terminal when boot-up' CONFIG_TERM_BLANKBOOTUP
  fi
  comment 'Ports'
  choice 'Port support' \
    "UART_0	CONFIG_SERIAL_UART0 \
     UART_1	CONFIG_SERIAL_UART1 \
     UART_2	CONFIG_SERIAL_UART2 \
     UART_3	CONFIG_SERIAL_UART3"

  comment 'Transfer Protocol'
  bool 'Support X-Modem' CONFIG_SERIAL_XMODEM
  bool 'Support Y-Modem' CONFIG_SERIAL_YMODEM
  #bool 'Support Z-Modem' CONFIG_SERIAL_ZMODEM

  comment 'Sanity check'
  bool 'Support MD5' CONFIG_MD5
fi

endmenu