bf533_ez-kit_flash_setup.asm

bf533平台图像采集程序

/******************************************************************************/
//
// Name: 	BF533 EZ-KIT video ITU-656 receive mode 
//
/******************************************************************************

(C) Copyright 2003 - Analog Devices, Inc.  All rights reserved.

File Name:	BF533_EZ-KIT_flash_setup.asm	

Date Modified:	10/25/04		TL		Rev 2

Software:       VisualDSP++3.1

Hardware:		ADSP-BF533 EZ-KIT Board

Special Connections:  None

Purpose:		To configure the ADV video devices 
				
				
Program Parameters:

*********************************************************************************/


#include <defBF533.h>

.global BF533_EZ_KIT_flash_setup;

//comunication setup of flash A on the EZ-KIT
// set asynch mem timing registers

//all banks enabled
#define en_async_mem 0xf

//all banks are configured in: 
//4 cycles transition time; 3 cycles setup time; 2 cycles hold time; 
//11 cycles read access time; 7 cycles write access time
#define amb0_timing 0x7bb0
#define amb1_timing 0x7bb0
#define amb2_timing 0x7bb0
#define amb3_timing 0x7bb0

#define flashA_sram 0x20240000	// base addr
#define flashA_csio 0x20270000	// base addr
#define portA_data_out 0x04	// offset
#define portB_data_out 0x05	// offset
#define portA_data_dir 0x06	// offset
#define portB_data_dir 0x07	// offset

/********************************************************************************/
.section L1_code;
BF533_EZ_KIT_flash_setup:

	//Async Memory Bank Control Register
    p0.h = hi(EBIU_AMBCTL0);
	p0.l = lo(EBIU_AMBCTL0);
	r0.l = amb0_timing;
	r0.h = amb1_timing;
	[p0] = r0;

	p0.h = hi(EBIU_AMBCTL1);
	p0.l = lo(EBIU_AMBCTL1);
	r0.l = amb2_timing;
	r0.h = amb3_timing;
	[p0] = r0;

	//Async Memory Global Control Register
	p0.h = hi(EBIU_AMGCTL);
	p0.l = lo(EBIU_AMGCTL);
	r0.l = w[p0];
	r1 = en_async_mem;
	r0 = r0 | r1;
	w[p0] = r0;		
	ssync;

	
	//Initialize flash A csio regs (port A)

    // clear data registers
	p1.h = hi(flashA_csio);
	p1.l = lo(flashA_csio) + portA_data_out;
	r0 = 0x0;
	w[p1] = r0;
	
    // direction control registers
	p1.h = hi(flashA_csio);
	p1.l = lo(flashA_csio) + portA_data_dir;
	r0 = 0xFFFF(Z);      // set dir=output
	w[p1] = r0;

BF533_EZ_KIT_flash_setup.END:
RTS;
/**************************************************************************/