kcompat.h

COPE the first practical network coding scheme which is developped on click

/*******************************************************************************

  
  Copyright(c) 1999 - 2004 Intel Corporation. All rights reserved.
  
  This program is free software; you can redistribute it and/or modify it 
  under the terms of the GNU General Public License as published by the Free 
  Software Foundation; either version 2 of the License, or (at your option) 
  any later version.
  
  This program is distributed in the hope that it will be useful, but WITHOUT 
  ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or 
  FITNESS FOR A PARTICULAR PURPOSE.  See the GNU General Public License for 
  more details.
  
  You should have received a copy of the GNU General Public License along with
  this program; if not, write to the Free Software Foundation, Inc., 59 
  Temple Place - Suite 330, Boston, MA  02111-1307, USA.
  
  The full GNU General Public License is included in this distribution in the
  file called LICENSE.
  
  Contact Information:
  Linux NICS <[e-mail]>
  Intel Corporation, 5200 N.E. Elam Young Parkway, Hillsboro, OR 97124-6497

*******************************************************************************/

#ifndef _KCOMPAT_H_
#define _KCOMPAT_H_

#include <linux/version.h>
#include <linux/types.h>
#include <linux/errno.h>
#include <linux/module.h>
#include <linux/pci.h>
#include <linux/netdevice.h>
#include <linux/ioport.h>
#include <linux/slab.h>
#include <linux/pagemap.h>
#include <linux/list.h>
#include <linux/sched.h>
#include <asm/io.h>

#ifndef IRQ_HANDLED
#define irqreturn_t void
#define IRQ_HANDLED
#define IRQ_NONE
#endif

#ifndef SET_NETDEV_DEV
#define SET_NETDEV_DEV(net, pdev)
#endif

#ifndef HAVE_FREE_NETDEV
#define free_netdev(x)	kfree(x)
#endif

#ifdef HAVE_POLL_CONTROLLER
#define CONFIG_NET_POLL_CONTROLLER
#endif

#ifdef E1000_NAPI
#undef CONFIG_E1000_NAPI
#define CONFIG_E1000_NAPI
#endif

#ifdef E1000_NO_NAPI
#undef CONFIG_E1000_NAPI
#endif

#ifndef module_param
#define module_param(v,t,p) MODULE_PARM(v, "i");
#endif

/*****************************************************************************/
#ifndef unlikely
#define unlikely(_x) _x
#define likely(_x) _x
#endif
/*****************************************************************************/

#ifndef PCI_DEVICE
#define PCI_DEVICE(vend,dev) \
	.vendor = (vend), .device = (dev), \
	.subvendor = PCI_ANY_ID, .subdevice = PCI_ANY_ID
#endif

/*****************************************************************************/
/* Installations with ethtool version without eeprom, adapter id, or statistics
 * support */
#ifndef ETHTOOL_GSTATS
#define ETHTOOL_GSTATS 0x1d
#undef ethtool_drvinfo
#define ethtool_drvinfo k_ethtool_drvinfo
struct k_ethtool_drvinfo {
	uint32_t cmd;
	char	 driver[32];
	char	 version[32];
	char	 fw_version[32];
	char	 bus_info[32];
	char	 reserved1[32];
	char	 reserved2[16];
	uint32_t n_stats;
	uint32_t testinfo_len;
	uint32_t eedump_len;
	uint32_t regdump_len;
};

struct ethtool_stats {
	uint32_t cmd;
	uint32_t n_stats;
	uint64_t data[0];
};

#ifndef ETHTOOL_PHYS_ID
#define ETHTOOL_PHYS_ID 0x1c
#ifndef ETHTOOL_GSTRINGS
#define ETHTOOL_GSTRINGS 0x1b
enum ethtool_stringset {
	ETH_SS_TEST             = 0,
	ETH_SS_STATS,
};
struct ethtool_gstrings {
	u32     cmd;            /* ETHTOOL_GSTRINGS */
	u32     string_set;     /* string set id e.c. ETH_SS_TEST, etc*/
	u32     len;            /* number of strings in the string set */
	u8      data[0];
};
#ifndef ETHTOOL_TEST
#define ETHTOOL_TEST 0x1a
enum ethtool_test_flags {
	ETH_TEST_FL_OFFLINE	= (1 << 0),
	ETH_TEST_FL_FAILED	= (1 << 1),
};
struct ethtool_test {
	uint32_t cmd;
	uint32_t flags;
	uint32_t reserved;
	uint32_t len;
	uint64_t data[0];
};
#ifndef ETHTOOL_GEEPROM
#define ETHTOOL_GEEPROM 0xb
#undef ETHTOOL_GREGS
struct ethtool_eeprom {
	uint32_t cmd;
	uint32_t magic;
	uint32_t offset;
	uint32_t len;
	uint8_t	 data[0];
};

struct ethtool_value {
	uint32_t cmd;
	uint32_t data;
};

#ifndef ETHTOOL_GLINK
#define ETHTOOL_GLINK 0xa
#endif /* Ethtool version without link support */
#endif /* Ethtool version without eeprom support */
#endif /* Ethtool version without test support */
#endif /* Ethtool version without strings support */
#endif /* Ethtool version wihtout adapter id support */
#endif /* Ethtool version without statistics support */

#ifndef ETHTOOL_GREGS
#define ETHTOOL_GREGS		0x00000004 /* Get NIC registers. */
#define ethtool_regs _kc_ethtool_regs
/* for passing big chunks of data */
struct _kc_ethtool_regs {
	u32	cmd;
	u32	version; /* driver-specific, indicates different chips/revs */
	u32	len; /* bytes */
	u8	data[0];
};
#endif
#ifndef ETHTOOL_GMSGLVL
#define ETHTOOL_GMSGLVL		0x00000007 /* Get driver message level */
#endif
#ifndef ETHTOOL_SMSGLVL
#define ETHTOOL_SMSGLVL		0x00000008 /* Set driver msg level, priv. */
#endif
#ifndef ETHTOOL_NWAY_RST
#define ETHTOOL_NWAY_RST	0x00000009 /* Restart autonegotiation, priv */
#endif
#ifndef ETHTOOL_GLINK
#define ETHTOOL_GLINK		0x0000000a /* Get link status */
#endif
#ifndef ETHTOOL_GEEPROM
#define ETHTOOL_GEEPROM		0x0000000b /* Get EEPROM data */
#endif
#ifndef ETHTOOL_SEEPROM
#define ETHTOOL_SEEPROM		0x0000000c /* Set EEPROM data */
#endif
#ifndef ETHTOOL_GCOALESCE
#define ETHTOOL_GCOALESCE	0x0000000e /* Get coalesce config */
/* for configuring coalescing parameters of chip */
#define ethtool_coalesce _kc_ethtool_coalesce
struct _kc_ethtool_coalesce {
	u32	cmd;	/* ETHTOOL_{G,S}COALESCE */

	/* How many usecs to delay an RX interrupt after
	 * a packet arrives.  If 0, only rx_max_coalesced_frames
	 * is used.
	 */
	u32	rx_coalesce_usecs;

	/* How many packets to delay an RX interrupt after
	 * a packet arrives.  If 0, only rx_coalesce_usecs is
	 * used.  It is illegal to set both usecs and max frames
	 * to zero as this would cause RX interrupts to never be
	 * generated.
	 */
	u32	rx_max_coalesced_frames;

	/* Same as above two parameters, except that these values
	 * apply while an IRQ is being serviced by the host.  Not
	 * all cards support this feature and the values are ignored
	 * in that case.
	 */
	u32	rx_coalesce_usecs_irq;
	u32	rx_max_coalesced_frames_irq;

	/* How many usecs to delay a TX interrupt after
	 * a packet is sent.  If 0, only tx_max_coalesced_frames
	 * is used.
	 */
	u32	tx_coalesce_usecs;

	/* How many packets to delay a TX interrupt after
	 * a packet is sent.  If 0, only tx_coalesce_usecs is
	 * used.  It is illegal to set both usecs and max frames
	 * to zero as this would cause TX interrupts to never be
	 * generated.
	 */
	u32	tx_max_coalesced_frames;

	/* Same as above two parameters, except that these values
	 * apply while an IRQ is being serviced by the host.  Not
	 * all cards support this feature and the values are ignored
	 * in that case.
	 */
	u32	tx_coalesce_usecs_irq;
	u32	tx_max_coalesced_frames_irq;

	/* How many usecs to delay in-memory statistics
	 * block updates.  Some drivers do not have an in-memory
	 * statistic block, and in such cases this value is ignored.
	 * This value must not be zero.
	 */
	u32	stats_block_coalesce_usecs;

	/* Adaptive RX/TX coalescing is an algorithm implemented by
	 * some drivers to improve latency under low packet rates and
	 * improve throughput under high packet rates.  Some drivers
	 * only implement one of RX or TX adaptive coalescing.  Anything
	 * not implemented by the driver causes these values to be
	 * silently ignored.
	 */
	u32	use_adaptive_rx_coalesce;
	u32	use_adaptive_tx_coalesce;

	/* When the packet rate (measured in packets per second)
	 * is below pkt_rate_low, the {rx,tx}_*_low parameters are
	 * used.
	 */
	u32	pkt_rate_low;
	u32	rx_coalesce_usecs_low;
	u32	rx_max_coalesced_frames_low;
	u32	tx_coalesce_usecs_low;
	u32	tx_max_coalesced_frames_low;

	/* When the packet rate is below pkt_rate_high but above
	 * pkt_rate_low (both measured in packets per second) the
	 * normal {rx,tx}_* coalescing parameters are used.
	 */

	/* When the packet rate is (measured in packets per second)
	 * is above pkt_rate_high, the {rx,tx}_*_high parameters are
	 * used.
	 */
	u32	pkt_rate_high;
	u32	rx_coalesce_usecs_high;
	u32	rx_max_coalesced_frames_high;
	u32	tx_coalesce_usecs_high;
	u32	tx_max_coalesced_frames_high;

	/* How often to do adaptive coalescing packet rate sampling,
	 * measured in seconds.  Must not be zero.
	 */
	u32	rate_sample_interval;
};
#endif
#ifndef ETHTOOL_SCOALESCE
#define ETHTOOL_SCOALESCE	0x0000000f /* Set coalesce config. */
#endif
#ifndef ETHTOOL_GRINGPARAM
#define ETHTOOL_GRINGPARAM	0x00000010 /* Get ring parameters */
/* for configuring RX/TX ring parameters */
#define ethtool_ringparam _kc_ethtool_ringparam
struct _kc_ethtool_ringparam {
	u32	cmd;	/* ETHTOOL_{G,S}RINGPARAM */

	/* Read only attributes.  These indicate the maximum number
	 * of pending RX/TX ring entries the driver will allow the
	 * user to set.
	 */
	u32	rx_max_pending;
	u32	rx_mini_max_pending;
	u32	rx_jumbo_max_pending;
	u32	tx_max_pending;

	/* Values changeable by the user.  The valid values are
	 * in the range 1 to the "*_max_pending" counterpart above.
	 */
	u32	rx_pending;
	u32	rx_mini_pending;
	u32	rx_jumbo_pending;
	u32	tx_pending;
};
#endif
#ifndef ETHTOOL_SRINGPARAM
#define ETHTOOL_SRINGPARAM	0x00000011 /* Set ring parameters, priv. */
#endif
#ifndef ETHTOOL_GPAUSEPARAM
#define ETHTOOL_GPAUSEPARAM	0x00000012 /* Get pause parameters */
/* for configuring link flow control parameters */
#define ethtool_pauseparam _kc_ethtool_pauseparam
struct _kc_ethtool_pauseparam {
	u32	cmd;	/* ETHTOOL_{G,S}PAUSEPARAM */

	/* If the link is being auto-negotiated (via ethtool_cmd.autoneg
	 * being true) the user may set 'autonet' here non-zero to have the
	 * pause parameters be auto-negotiated too.  In such a case, the
	 * {rx,tx}_pause values below determine what capabilities are
	 * advertised.
	 *
	 * If 'autoneg' is zero or the link is not being auto-negotiated,
	 * then {rx,tx}_pause force the driver to use/not-use pause
	 * flow control.
	 */
	u32	autoneg;
	u32	rx_pause;
	u32	tx_pause;
};
#endif
#ifndef ETHTOOL_SPAUSEPARAM
#define ETHTOOL_SPAUSEPARAM	0x00000013 /* Set pause parameters. */
#endif
#ifndef ETHTOOL_GRXCSUM
#define ETHTOOL_GRXCSUM		0x00000014 /* Get RX hw csum enable (ethtool_value) */
#endif
#ifndef ETHTOOL_SRXCSUM
#define ETHTOOL_SRXCSUM		0x00000015 /* Set RX hw csum enable (ethtool_value) */
#endif
#ifndef ETHTOOL_GTXCSUM