imote2.cfg

一个烧写FLASH的软件

# iMote2
#
if { [info exists CHIPNAME] } {	
   set  _CHIPNAME $CHIPNAME    
} else {	 
   set  _CHIPNAME imote2
}

if { [info exists ENDIAN] } {	
   set  _ENDIAN $ENDIAN    
} else {	 
   set  _ENDIAN little
}

if { [info exists CPUTAPID ] } {
   set _CPUTAPID $CPUTAPID
} else {
  # force an error till we get a good number
   set _CPUTAPID 0xffffffff
}

# PXA271 and an Intel Strataflash of 32 Megabytes (p30)
# 
# Marvell/Intel PXA270 Script
# set jtag_nsrst_delay to the delay introduced by your reset circuit
# the rest of the needed delays are built into the openocd program
jtag_nsrst_delay 800 
# set the jtag_ntrst_delay to the delay introduced by a reset circuit
# the rest of the needed delays are built into the openocd program
jtag_ntrst_delay 0
#use combined on interfaces or targets that can't set TRST/SRST separately
reset_config trst_and_srst separate
#jtag scan chain

jtag newtap $_CHIPNAME cpu -irlen 7 -ircapture 0x1 -irmask 0x7f -expected-id $_CPUTAPID

set _TARGETNAME [format "%s.cpu" $_CHIPNAME]
target create $_TARGETNAME xscale -endian $_ENDIAN -chain-position $_TARGETNAME -variant pxa27x
$_TARGETNAME configure -work-area-virt 0x0x5c000000 -work-area-phys 0x0x5c000000 -work-area-size 0x10000 -work-area-backup 1
# maps to PXA internal RAM. If you are using a PXA255
# you must initialize SDRAM or leave this option off


#flash bank <driver> <base> <size> <chip_width> <bus_width>
# works for P30 flash
flash bank cfi 0x00000000 0x2000000 2 2 0