netsim.dll

BOSON NETSIM是目前最好的路由器模拟软件

device,"router","0",,,,,,,,,
device,"switch1900","0",,,,,,,,,
device,"switch5000","0",,,,,,,,,
mode,"nologmode","Press Enter","3",,,,,,,,,
mode,"usermode",">","3",,,,,,,,,
mode,"privmode","#","3",,,,,,,,,
mode,"globmode","(config)#","3",,,,,,,,,
mode,"ethemode","(config-if)","3",,,,,,,,,
mode,"serimode","(config-if)","3",,,,,,,,,
mode,"brimode","(config-if)","3",,,,,,,,,
cmd1,"show","Show running system information","","","","2",,,,,,,,,
cmd1,"enable","Turn on privileged commands","","","","2",,,,,,,,,
cmd1,"exit","Exit from the EXEC","","","","2",,,,,,,,,
cmd1,"help","Description of the interactive help system","","","","2",,,,,,,,,
cmd1,"disable","Turn off privileged commands","","","","2",,,,,,,,,
cmd1,"configure","Enter configuration mode","","","","3",,,,,,,,,
cmd1,"exit","","","","","4",,,,,,,,,
cmd1,"end","","","","","4",,,,,,,,,
cmd1,"hostname","","","","","4",,,,,,,,,
cmd1,"clear","Reset functions","","","","3",,,,,,,,,
cmd1,"copy","Copy from one file to another","","","","3",,,,,,,,,
cmd1,"disconnect","Disconnect an existing network connection","","","","2",,,,,,,,,
cmd1,"erase","Erase a filesystem","","","","3",,,,,,,,,
cmd1,"logout","Exit from the EXEC","","","","2",,,,,,,,,
cmd1,"ping","Send echo messages","","","","2",,,,,,,,,
cmd1,"reload","Halt and perform a cold restart","","","","3",,,,,,,,,
cmd1,"telnet","Open a telnet connection","","","","2",,,,,,,,,
cmd1,"terminal","Set terminal line parameters","","","","2",,,,,,,,,
cmd1,"traceroute","Trace route to destination","","","","2",,,,,,,,,
cmd1,"write","Write running configuration","","","","2",,,,,,,,,
cmd1,"interface","hi","","","","4",,,,,,,,,
cmd1,"Exit","Exit from interface configuration mode","","","","5",,,,,,,,,
cmd1,"Exit","Exit from interface configuration mode","","","","6",,,,,,,,,
cmd1,"Exit","Exit from interface configuration mode","","","","7",,,,,,,,,
cmd1,"shutdown","Shutdown the selected interface","","","","5",,,,,,,,,
cmd1,"shutdown","Shutdown the selected interface","","","","6",,,,,,,,,
cmd1,"shutdown","Shutdown the selected interface","","","","7",,,,,,,,,
cmd1,"cdp","Global CDP configuration subcommands","","","","4",,,,,,,,,
cmd1,"end","Exit Configuration Mode","","","","6",,,,,,,,,
cmd1,"End","Exit Configuration Mode","","","","5",,,,,,,,,
cmd1,"CDP","CDP interface subcommands","","","","5",,,,,,,,,
cmd1,"CDP","CDP interface subcommands","","","","6",,,,,,,,,
cmd1,"CDP","CDP interface subcommands","","","","7",,,,,,,,,
cmd1,"end","Exit Configuration Mode","","","","7",,,,,,,,,
cmd2,"version","System hardware and software status","","","","1",,,,,,,,,
cmd2,"ip","IP information","","","","1",,,,,,,,,
cmd2,"interface","Interface status and configuration","","","","1",,,,,,,,,
cmd2,"<cr>","","","","","3",,,,,,,,,
cmd2,"<cr>","","","","","4",,,,,,,,,
cmd2,"<cr>","","","","","6",,,,,,,,,
cmd2,"terminal","Configure from the terminal","","","","7",,,,,,,,,
cmd2,"<cr>","","","","","9",,,,,,,,,
cmd2,"<cr>","","","","","8",,,,,,,,,
cmd2,"WORD","This system's network name","WORD","","","10",,,,,,,,,
cmd2,"flash","Copy from flash: file system","","","","12",,,,,,,,,
cmd2,"running-config","Copy from current system configuration","","","","12",,,,,,,,,
cmd2,"startup-config","Copy from startup configuration","","","","12",,,,,,,,,
cmd2,"tftp","Copy from tftp: file system","","","","12",,,,,,,,,
cmd2,"startup-config","Erase contents of configuration memory","","","","14",,,,,,,,,
cmd2,"arp","ARP table","","","","1",,,,,,,,,
cmd2,"cdp","CDP information","","","","1",,,,,,,,,
cmd2,"clock","Display the system clock","","","","1",,,,,,,,,
cmd2,"flash","display information about flash: file system","","","","1",,,,,,,,,
cmd2,"history","Display the session command history","","","","1",,,,,,,,,
cmd2,"hosts","IP domain-name, nameservers, and host table","","","","1",,,,,,,,,
cmd2,"interfaces","Interface status and configuration","","","","1",,,,,,,,,
cmd2,"ipx","Novell IPX information","","","","1",,,,,,,,,
cmd2,"protocols","Active network routing protocols","","","","1",,,,,,,,,
cmd2,"sessions","Information about Telnet connections","","","","1",,,,,,,,,
cmd2,"terminal","Display terminal configuration parameters","","","","1",,,,,,,,,
cmd2,"users","Display information about terminal lines","","","","1",,,,,,,,,
cmd2,"frame-relay","Frame-Relay information","","","","1",,,,,,,,,
cmd2,"running-config","Current operating configuration","","","","1",,,,,,,,,
cmd2,"startup-config","Contents of startup configuration","","","","1",,,,,,,,,
cmd2,"history","Enable and control the command history function","","","","19",,,,,,,,,
cmd2,"no","Negate a command or set its defaults","","","","19",,,,,,,,,
cmd2,"ip","IP Trace","","","","20",,,,,,,,,
cmd2,"ipx","IPX Trace","","","","20",,,,,,,,,
cmd2,"memory","Write to NV memory","","","","21",,,,,,,,,
cmd2,"BRI","ISDN Basic Rate Interface","Range","","","22",,,,,,,,,
cmd2,"Ethernet","Ethernet IEEE 802.3","WORD","","","22",,,,,,,,,
cmd2,"Serial","Serial","Range","","","22",,,,,,,,,
cmd2,"<cr>","","","","","23",,,,,,,,,
cmd2,"<cr>","","","","","25",,,,,,,,,
cmd2,"<cr>","","","","","26",,,,,,,,,
cmd2,"<cr>","","","","","27",,,,,,,,,
cmd2,"<cr>","","","","","28",,,,,,,,,
cmd2,"<cr>","","","","","29",,,,,,,,,
cmd2,"advertise-v2","CDP sends version-2 advertisements","","","","30",,,,,,,,,
cmd2,"holdtime","Specify the holdtime (in sec) to be sent in packets","","","","30",,,,,,,,,
cmd2,"timer","Specify the rate at which CDP packets are sent(in sec)","","","","30",,,,,,,,,
cmd2,"run","","","","","30",,,,,,,,,
cmd2,"<cr>","","","","","31",,,,,,,,,
cmd2,"<cr>","","","","","32",,,,,,,,,
cmd2,"enable","Enable CDP on interface","","","","33",,,,,,,,,
cmd2,"","","","","","33",,,,,,,,,
cmd2,"enable","Enable CDP on interface","","","","34",,,,,,,,,
cmd2,"enable","Enable CDP on interface","","","","35",,,,,,,,,
cmd3,"route","IP routing table","","","","2",,,,,,,,,
cmd3,"protocols","IP routing protocol process parameters","","","","2",,,,,,,,,
cmd3,"<cr>","","","","","1",,,,,,,,,
cmd3,"<cr>","","","","","7",,,,,,,,,
cmd3,"tftp","Copy to tftp: file system","","","","11",,,,,,,,,
cmd3,"startup-config","Copy to startup configuration","","","","12",,,,,,,,,
cmd3,"tftp","Copy to tftp: file system","","","","12",,,,,,,,,
cmd3,"running-config","Update (merge with) current system configuration","","","","13",,,,,,,,,
cmd3,"tftp","Copy to tftp: file system","","","","13",,,,,,,,,
cmd3,"running-config","Update (merge with) current system configuration","","","","14",,,,,,,,,
cmd3,"startup-config","Copy to startup configuration","","","","14",,,,,,,,,
cmd3,"entry"," Information for specific neighbor entry","","","","17",,,,,,,,,
cmd3,"interface","CDP interface status and configuration","","","","17",,,,,,,,,
cmd3,"neighbors","CDP neighbor entries","","","","17",,,,,,,,,
cmd3,"traffic","CDP statistics","","","","17",,,,,,,,,
cmd3,"map","Frame-Relay map table","","","","29",,,,,,,,,
cmd3,"pvc","show frame relay pvc statistics","","","","29",,,,,,,,,
cmd3,"access-list","IPX access lists","","","","24",,,,,,,,,
cmd3,"route","IPX routing table","","","","24",,,,,,,,,
cmd3,"traffic","IPX protocol statistics","","","","24",,,,,,,,,
cmd3,"size","Set history buffer size","","","","32",,,,,,,,,
cmd3,"editing","Enable command line editing","","","","33",,,,,,,,,
cmd3,"<cr>","","","","","19",,,,,,,,,
cmd3,"<cr>","","","","","30",,,,,,,,,
cmd3,"<0-2>","Serial interface number","Range","","","39",,,,,,,,,
cmd3,"<0-2>","Ethernet interface number","Range","","","38",,,,,,,,,
cmd3,"<0-2>","BRI interface number","Range","","","37",,,,,,,,,
cmd3,"<cr>","","","","","49",,,,,,,,,
cmd3,"<10-255>","Length  of time  (in sec) that receiver must keep this packet","WORD","","","50",,,,,,,,,
cmd3,"<5-254>","Rate at which CDP packets are sent (in  sec)","WORD","","","51",,,,,,,,,
cmd3,"<cr>","","","","","52",,,,,,,,,
cmd3,"<cr>","","","","","17",,,,,,,,,
cmd3,"<cr>","","","","","55",,,,,,,,,
cmd3,"<cr>","","","","","58",,,,,,,,,
cmd3,"<cr>","","","","","57",,,,,,,,,
cmd4,"detail","Show detailed information","","","","14",,,,,,,,,
cmd4,"rip","Routing Information Protocol (RIP)","","","","1",,,,,,,,,
cmd4,"<cr>","","","","","27",,,,,,,,,
cmd4,"<cr>","","","","","26",,,,,,,,,
cmd4,"<cr>","","","","","25",,,,,,,,,
cmd4,"<cr>","","","","","29",,,,,,,,,
cmd4,"<cr>","","","","","14",,,,,,,,,
cmd4,"<cr>","","","","","13",,,,,,,,,
cmd4,"WORD","Name of CDP neighbor entry","WORD","","","12",,,,,,,,,
cmd5,"<cr>","","","","","1",,,,,,,,,
cmd5,"<cr>","","","","","9",,,,,,,,,