callout_reboot_mb8x.s

来自「QNX ADS BSP code for i.MX27 chips」· S 代码 · 共 76 行

#  
# Copyright 2007, QNX Software Systems. 
#  
# Licensed under the Apache License, Version 2.0 (the "License"). You 
# may not reproduce, modify or distribute this software except in 
# compliance with the License. You may obtain a copy of the License 
# at: http://www.apache.org/licenses/LICENSE-2.0 
#  
# Unless required by applicable law or agreed to in writing, software 
# distributed under the License is distributed on an "AS IS" basis, 
# WITHOUT WARRANTIES OF ANY KIND, either express or implied.
# 
# This file may contain contributions from others, either as 
# contributors under the License or as licensors under other terms.  
# Please review this entire file for other proprietary rights or license 
# notices, as well as the QNX Development Suite License Guide at 
# http://licensing.qnx.com/license-guide/ for other information.
# 
/*
 * Fujitsu MB8X system reboot
 */

#include "callout.ah"
#include <arm/mb8x.h>

/*
 * -----------------------------------------------------------------------
 * Routine to patch callout code
 *
 * On entry:
 *	r0 - physical address of syspage
 *	r1 - virtual  address of syspage
 *	r2 - offset from start of syspage to start of the callout routine
 *	r3 - offset from start of syspage to read/write data used by callout
 * -----------------------------------------------------------------------
 */

patch_reboot:
	stmdb	sp!,{r4,lr}
	add		r4, r0, r2					// address of callout routine

	/*
	 * Map reset control registers
	 */
	mov		r0, #0x40	// size of reset control registers
	ldr		r1, Lpaddr
	bl		callout_io_map

	/*
	 * Patch the callout routine
	 */
	CALLOUT_PATCH	r4, r0, r1, r2, ip
	ldmia	sp!,{r4,pc}

Lpaddr:	.word	MB8X_CRG_CTRL_BASE


CALLOUT_START(reboot_mb8x, 0, patch_reboot)
    /*
     * Get the base address of Clock, Reset, and Power Mode Control registers (patched)
     */

    mov     ip,     #0x000000ff
    orr     ip, ip, #0x0000ff00
    orr     ip, ip, #0x00ff0000
    orr     ip, ip, #0xff000000

	mov		r0, #0x02	/* SW_RST bit */
    ldr     r1, [ip, #MB8X_CRG_CRSR]
    orr     r1, r1, r0
	strh	r1, [ip, #MB8X_CRG_CRSR]


CALLOUT_END(reboot_mb8x)