kconfig

来自「底层驱动开发」· 代码 · 共 47 行

#
# Acorn Network device configuration
#  These are for Acorn's Expansion card network interfaces
#
config ARM_AM79C961A
	bool "ARM EBSA110 AM79C961A support"
	depends on NET_ETHERNET && ARM && ARCH_EBSA110
	select CRC32
	help
	  If you wish to compile a kernel for the EBSA-110, then you should
	  always answer Y to this.

config ARM_ETHER1
	tristate "Acorn Ether1 support"
	depends on NET_ETHERNET && ARM && ARCH_ACORN
	help
	  If you have an Acorn system with one of these (AKA25) network cards,
	  you should say Y to this option if you wish to use it with Linux.

config ARM_ETHER3
	tristate "Acorn/ANT Ether3 support"
	depends on NET_ETHERNET && ARM && ARCH_ACORN
	help
	  If you have an Acorn system with one of these network cards, you
	  should say Y to this option if you wish to use it with Linux.

config ARM_ETHERH
	tristate "I-cubed EtherH/ANT EtherM support"
	depends on NET_ETHERNET && ARM && ARCH_ACORN
	select CRC32
	help
	  If you have an Acorn system with one of these network cards, you
	  should say Y to this option if you wish to use it with Linux.

config ARM_ETHER00
	tristate "Altera Ether00 support"
	depends on NET_ETHERNET && ARM && ARCH_CAMELOT
	help
	  This is the driver for Altera's ether00 ethernet mac IP core. Say
	  Y here if you want to build support for this into the kernel. It
	  is also available as a module (say M here) that can be inserted/
	  removed from the kernel at the same time as the PLD is configured.
	  If this driver is running on an epxa10 development board then it
	  will generate a suitable hw address based on the board serial
	  number (MTD support is required for this). Otherwise you will
	  need to set a suitable hw address using ifconfig.