fpu_syst.h

汇编源码大全 有各种汇编源码 希望对你有所帮助

/*---------------------------------------------------------------------------+
 |  fpu_system.h							     |
 |									     |
 | Copyright (C) 1992,1994						     |
 |			 W. Metzenthen, 22 Parker St, Ormond, Vic 3163,      |
 |			 Australia.  E-mail   [e-mail]    |
 |									     |
 +---------------------------------------------------------------------------*/

#ifndef _FPU_SYSTEM_H
#define _FPU_SYSTEM_H

/* system dependent definitions */

#include <linux/sched.h>
#include <linux/kernel.h>
#include <sys/signal.h>

/* This sets the pointer FPU_info to point to the argument part
   of the stack frame of math_emulate() */
#define SETUP_DATA_AREA(arg)	FPU_info = (struct info *) &arg

#ifdef RSX
struct my_task_struct {
    union i387_union i387;
    unsigned long _reserved;
} ;
extern struct my_task_struct *process_npx;
#define I387			(process_npx->i387)
#define FPU_info		(I387.soft.info)

#else /* NOT RSX */
#define I387			(current->tss.i387)
#define FPU_info		(I387.soft.info)
#endif

#define FPU_CS			(*(unsigned short *) &(FPU_info->___cs))
#define FPU_SS			(*(unsigned short *) &(FPU_info->___ss))
#define FPU_DS			(*(unsigned short *) &(FPU_info->___ds))
#define FPU_EAX 		(FPU_info->___eax)
#define FPU_EFLAGS		(FPU_info->___eflags)
#define FPU_EIP 		(FPU_info->___eip)
#define FPU_ORIG_EIP		(FPU_info->___orig_eip)

#define FPU_lookahead		(I387.soft.lookahead)
#define FPU_entry_eip		(I387.soft.entry_eip)

#define partial_status		(I387.soft.swd)
#define control_word		(I387.soft.cwd)
#define regs			(I387.soft.regs)
#define top			(I387.soft.top)

#define ip_offset		(I387.soft.fip)
#define cs_selector		(I387.soft.fcs)
#define data_operand_offset	(I387.soft.foo)
#define operand_selector	(I387.soft.fos)

#ifdef RSX
#define FPU_verify_area(x,y,z)	;
#else
#define FPU_verify_area(x,y,z)	if ( verify_area(x,y,z) ) \
				math_abort(FPU_info,SIGSEGV)
#endif

#undef FPU_IGNORE_CODE_SEGV
#ifdef FPU_IGNORE_CODE_SEGV
/* verify_area() is very expensive, and causes the emulator to run
   about 20% slower if applied to the code. Anyway, errors due to bad
   code addresses should be much rarer than errors due to bad data
   addresses. */
#define FPU_code_verify_area(z)
#else
/* A simpler test than verify_area() can probably be done for
   FPU_code_verify_area() because the only possible error is to step
   past the upper boundary of a legal code area. */
#define FPU_code_verify_area(z) FPU_verify_area(VERIFY_READ,(void *)FPU_EIP,z)
#endif

/* ######## temporary and ugly ;-) */
#define FPU_data_address	((void *)(I387.soft.twd))

#endif