main_define.h

来自「一个用MCU将SHARP 遥控码转为NEC码的小程序」· C头文件 代码 · 共 43 行

#ifndef DEFINE_H_
#define DEFINE_H_

#define uchar unsigned char
#define uint unsigned int

//#define IR_TYPE  1
#define NEC_IR_TYPE    0
#define SHARP_IR_TYPE  1

#define SUPPORT_IRKEY_ARRAY 0
#define IR_OK 1
#define IR_EEROR 0
#define IR_SEND_END 0
#define IR_RECEIVE_SYS_CODE  0x10

#define SUPPORT_INT1   0

sbit LED_GREEN=P1^0;
sbit LED_RED=P1^1;
// sbit int0=P3^2;

#if SUPPORT_IRKEY_ARRAY
extern data uchar IR_IN_SHARP_IRKEY_ARRAY[5][2];
extern data  uchar IR_SEND_NEC_IRKEY_ARRAY[5];
#endif

void init_mcu(void);

// -------------------ir send function------------------
void delay_xms(uchar i );
void delay_560us(uchar i);
void ir_send_code_0_bit();
void ir_send_code_1_bit();
void ir_send_code_one_bit(bit state);
void ir_send_start_code(void);
void ir_send_stop_code(void);
void ir_send_sys_code(void);
void ir_send_command_code(uchar command_code);
bit  ir_send(uchar ir_code);
// -------------------ir send function------------------
#endif //#ifndef DEFINE_H_