irqs.h

来自「em86xx 完整启动程序,支持网络下载与串通下载」· C头文件 代码 · 共 44 行

/*
 * include/asm-arm/arch-em86xx/board-generic/irqs.h
 *
 * Copyright (C) 2003-2004 Sigma Designs, Inc
 * 
 * Sigma Designs Evaluation Boards
 */

#ifndef __ASM_ARCH_BOARD_IRQS_H
#define __ASM_ARCH_BOARD_IRQS_H

// GPIO 6 - IRQ_GPIO0 - IDE_INT (active high)
// GPIO 8 - IRQ_GPIO1 - PCI_INT_A of PCI IDSEL 1, 3 (active low)
// GPIO 9 - IRQ_GPIO2 - PCI_INT_A / PCI_INT_B / PCI_INT_C / PCI_INT_D (active low)
// GPIO 9 - IRQ_GPIO2 - PCIFPGA_INT (active high)

// edge detector configuration
#define BOARDIRQMASK_VALID              0x0001e000  // ---- ---- ---- ---1 111- ---- ---- ----
#define BOARDIRQMASK_RISINGEDGE         0x00000000  // ---- ---- ---- ---0 000- ---- ---- ----
#ifdef CONFIG_ENABLE_PCIHOST_PCIFPGA
#define BOARDIRQMASK_FALLINGEDGE        0x00018000  // ---- ---- ---- ---1 100- ---- ---- ----
#define BOARDIRQMASK_LOWLEVEL           0x00000000  // ---- ---- ---- ---0 000- ---- ---- ----
#else
#define BOARDIRQMASK_FALLINGEDGE        0x0001e000  // ---- ---- ---- ---1 111- ---- ---- ----
#define BOARDIRQMASK_LOWLEVEL           0x0000e000  // ---- ---- ---- ---0 111- ---- ---- ----
#endif

#if defined(CONFIG_ARCH_TANGO15) && (CONFIG_ARCH_TANGO15_REV > 1) /* Tango15 Rev B or above */
#define BOARDIRQMASK_RISINGEDGE_HI      0x00000000  // 0000 0000 0000 0000 ---- ---- ---- ----
#define BOARDIRQMASK_FALLINGEDGE_HI     0x00000000  // 0000 0000 0000 0000 ---- ---- ---- ----
#endif

// board specific interrupts
#define IRQ_IDE                         IRQ_GPIO0
#define IRQ_PCIFPGA                     IRQ_GPIO2

#define SOFTIRQ_PCIFPGA                 15

// PCI interrupt mapping
#define PCI_IRQ_MAP(idsel, irqpin)      ((idsel) == 3 ? IRQ_GPIO1 : IRQ_GPIO2)

#endif