proadammsg.txt

proe5.0野火版下载(中文版免费下载)

Enter Manikin Filename
Enter Manikin Filename
#
#
%CE Error saving Perspective View ProADAM
ERROR: The view could not be saved.
#
#
%CIUSER Snook Carry Test results: Design Wt=%0f; Perc Male=%1f; Perc Fem=%2f
Snook Carry Test results: Design Wt=%0f; Perc Male=%1f; Perc Fem=%2f
#
#
%CIUSER Snook Lift/Lower Test results: Design Wt=%0f; Perc Male=%1f; Perc Fem=%2f
Snook Lift/Lower Test results: Design Wt=%0f; Perc Male=%1f; Perc Fem=%2f
#
#
%CIUSER NIOSH Lift/Lower Test results: RWL Origin=%0f; LI Origin=%0f; RWL Dest=%0f; LI Dest=%0f
NIOSH Lift/Lower Test results: RWL Origin=%0f; LI Origin=%0f; RWL Dest=%0f; LI Dest=%0f
#
#
%CE No manikins in the scene
ERROR: There is no manikins in the scene.
#
#
%CE WRONG_MANIKIN_SELECTION_1
ERROR: The selection you made is not a manikin.
#
#
%CE WRONG_MANIKIN_SELECTION_2
ERROR: You should make the selection from one manikin.
#
#
%CP MAKE_POSTURE_SELECTION
Make the selection to save the posture and press OK or the mouse CENTER BUTTON.
#
#
%CP MAKE_RESET_POSTURE_SELECTION
Make the selection to reset the posture and press OK or the mouse CENTER BUTTON.
#
#
%CW RANGE_OF_MOTION_EXCEEDED
The following DOF exceed the current range of motion:
#
#
%CW CANNOT_CREATE_JOINT_CONTRAINT	
Contraint cannot be created for the following joints:
#
#
%CP Drag_Mode_2DPoint
Drag Mode: 2DPoint
#
#
%CP Drag_Mode_2DBody
Drag Mode: 2DBody
#
#
%CP Drag_Mode_Rotation_around_Axis
Drag Mode: Rotation around Axis
#
#
%CP Drag_Mode_Manikin_Axis
Drag Mode: Manikin Axis
#
#
%CP Drag_Mode_Segment_Axis
Drag Mode: Segment Axis
#
#
USER - %0w
- %0w
#
#
%CP MAKE_DYNAMIC_RECTANGLE
Select the area of your posture with the dynamic rectangle 
#
#
%CW ERROR_MAKING_RECTANLE
Use the mouse LEFT BUTTON to draw the rectangle
#
#
%CI The posture was correctly saved at: %0w
The posture was correctly saved at: %0w
#
#
%CE ERROR_SAVING_POSTURE
ERROR: Saving posture aborted.
#
#
%CW WARNING_CREATE_CONSTRAINTS
Some constraints could not be created.