serial.c

来自「LP236X的教程里面有许多源码例程。我当初可是花钱买来的。希望能帮得上忙。」· C语言 代码 · 共 66 行

/******************************************************************************/
/* SERIAL.C: Low Level Serial Routines                                        */
/******************************************************************************/
/* This file is part of the uVision/ARM development tools.                    */
/* Copyright (c) 2005-2006 Keil Software. All rights reserved.                */
/* This software may only be used under the terms of a valid, current,        */
/* end user licence from KEIL for a compatible version of KEIL software       */
/* development tools. Nothing else gives you the right to use this software.  */
/******************************************************************************/

#include <LPC23xx.H>                     /* LPC23xx definitions               */

#define UART0                            /* Use UART 0 for printf             */

/* If UART 0 is used for printf                                               */
#ifdef UART0
  #define UxFDR  U0FDR
  #define UxLCR  U0LCR
  #define UxDLL  U0DLL
  #define UxDLM  U0DLM
  #define UxLSR  U0LSR
  #define UxTHR  U0THR
  #define UxRBR  U0RBR
/* If UART 1 is used for printf                                               */
#elif defined(UART1)
  #define UxFDR  U1FDR
  #define UxLCR  U1LCR
  #define UxDLL  U1DLL
  #define UxDLM  U1DLM
  #define UxLSR  U1LSR
  #define UxTHR  U1THR
  #define UxRBR  U1RBR
#endif


void init_serial (void)  {               /* Initialize Serial Interface       */
  #ifdef UART0
    PINSEL0 |= 0x00000050;               /* Enable TxD0 and RxD0              */
  #elif defined (UART1)
    PINSEL0 |= 0x40000000;               /* Enable TxD1                       */
    PINSEL1 |= 0x00000001;               /* Enable RxD1                       */
  #endif
  UxFDR    = 0;                          /* Fractional divider not used       */
  UxLCR    = 0x83;                       /* 8 bits, no Parity, 1 Stop bit     */
  UxDLL    = 94;                         /* 9600 Baud Rate @ 14.4 MHZ PCLK    */
  UxDLM    = 0;                          /* High divisor latch = 0            */
  UxLCR    = 0x03;                       /* DLAB = 0                          */
}


/* Implementation of putchar (also used by printf function to output data)    */
int sendchar (int ch)  {                 /* Write character to Serial Port    */

  while (!(UxLSR & 0x20));

  return (UxTHR = ch);
}


int getkey (void)  {                     /* Read character from Serial Port   */

  while (!(UxLSR & 0x01));

  return (UxRBR);
}