define.h

控制台达变频器 控制台达变频器

//  writeread.c
#define         WriteDeviceAddress     0xa0
#define         ReadDviceAddress       0xa1
#define         WriteDevice8563        0xa2
#define         ReadDevice8563         0xa3

//  keysub.c
#define         KEY_MODE               1
#define         KEY_SET                2
#define         KEY_ENTER              3
#define         KEY_ESC                4
#define         KEY_MODE_ENTER         5
#define         KEY_MODE_ESC           6
#define         KEY_UP                 7
#define         KEY_DOWN               8
#define         KEY_NEXT               9
#define         KEY_BACK               10
#define         KEY_MODE_DOWN          11
#define         KEY_MODE_UP            12

// subdd.c
#define         TRAN_OFFSET            5
#define         TRAN_SUCCESS           1
#define         TRAN_FAIL              2
//    如果30秒内仍然有错误出现则显示错误信息
#define         ESC_TIME_MAX           10
//    如果250秒内仍然有错误出现则显示错误信息
#define         ENTER_TIME_MAX         250
#define         WRITEERROR_TIME_MAX    2
#define         HELP_MAX               5
#define         TRAN_DELAY_MAX         20

// subddc.h
#define         DEC_CODE               16
#define         XIE_CODE               17
#define         C_MH_CODE              18
#define         E_MH_CODE              19
#define         ADD_CODE               20

#define         PT_READ24C02_START     0x40
#define         PT_READ24C02_END       0xf8
#define         START_24C02_ADDRESS    0x40
#define         END_24C02_ADDRESS      0xf8
#define         PT_WRITE24C02_ADDRESS  0x35
#define         PT_READ24C02_ADDRESS   0x36
#define         RECE_CONST             3
#define         TRRE_GAP_MAX           5

//   subddc.c
#define         QSBH_CODE              1
#define         GYBH_CODE              2
#define         DYBH_CODE              3
#define         YYBH_CODE              4
#define         YSJBH_CODE             5
#define         FJBH_CODE              6
#define         SBBH_CODE              7
#define         QXBH_CODE              8



sbit    clr_wdt=P1^0;         // ????
sbit	DI=P1^1;
sbit	W_R=P1^2;
sbit	E=P1^3;
sbit	CS1=P1^4;
sbit	CS2=P1^5;
sbit    SDA=P1^6;
sbit    SCL=P1^7;

sbit    GROUND_LED=P3^4;
sbit    BUZZER=P3^5;
sbit    STATUS_LED=P2^6;
sbit    tran_en=P2^7;

//--------------------key-------------

#define         KEY_MAX		       13
#define         KEY_CONST              0x38