uart_test01.c

avr单片机的串口程序

//ICC-AVR application builder : 2008-8-1 下午 10:46:25
// Target : M48
// Crystal: 8.0000Mhz

#include <iom48v.h>
#include <macros.h>

void port_init(void)
{
 PORTB = 0x00;
 DDRB  = 0x00;
 PORTC = 0x00; //m103 output only
 DDRC  = 0x00;
 PORTD = 0x00;
 DDRD  = 0x00;
}

//UART0 initialize
// desired baud rate: 9600
// actual: baud rate:9615 (0.2%)
void uart0_init(void)
{
 UCSR0B = 0x00; //disable while setting baud rate
 UCSR0A = 0x00;
 UCSR0C = 0x06;
 UBRR0L = 0x33; //set baud rate lo
 UBRR0H = 0x00; //set baud rate hi
 UCSR0B = 0x18;
}

//call this routine to initialize all peripherals
void init_devices(void)
{
 //stop errant interrupts until set up
 CLI(); //disable all interrupts
 port_init();
 uart0_init();

 MCUCR = 0x00;
 EICRA = 0x00; //extended ext ints
 EIMSK = 0x00;
 
 TIMSK0 = 0x00; //timer 0 interrupt sources
 TIMSK1 = 0x00; //timer 1 interrupt sources
 TIMSK2 = 0x00; //timer 2 interrupt sources
 
 PCMSK0 = 0x00; //pin change mask 0 
 PCMSK1 = 0x00; //pin change mask 1 
 PCMSK2 = 0x00; //pin change mask 2
 PCICR = 0x00; //pin change enable 
 PRR = 0x00; //power controller
 SEI(); //re-enable interrupts
 //all peripherals are now initialized
}