opentimer23.c

Mplab C30编译器

#if defined(__PIC24F__)
#include <p24Fxxxx.h>
#endif
#include <timer.h>

/*******************************************************************************
Function Prototype : void OpenTimer23(unsigned int config,unsigned int period)
 
Include            : timer.h
 
Description        : This function configures the 32-bit timer module.
 
Arguments          : config - This contains the parameters to be configured in
                     the T2CON register as defined below
						Timer Module On/Off						
						   T23_ON						
						   T23_OFF						
						Timer Module Idle mode On/Off						
						   T23_IDLE_CON						
						   T23_IDLE_STOP						
						Timer Gate time accumulation enable						
						   T23_GATE_ON						
						   T23_GATE_OFF						
						Timer prescaler						
						   T23_PS_1_1						
						   T23_PS_1_8						
						   T23_PS_1_64						
						   T23_PS_1_256						
						Timer Synchronous clock enable						
						   T23_SYNC_EXT_ON						
						   T23_SYNC_EXT_OFF						
						Timer clock source						
						   T23_SOURCE_EXT						
						   T23_SOURCE_INT						
					  period - This contains the period match value to be stored 
					  into the PR register 
 
Return Value      : None
 
Remarks           : This function configures the 32-bit Timer Control register and 
                    sets the period match value into the PR register. 
**********************************************************************************/
#if defined(_TIMER2) && defined(_TIMER3)

void OpenTimer23(unsigned int  config,unsigned long period)
{
    TMR2 = 0;               /* Reset Timer2 to 0x0000 */
    TMR3 = 0;               /* Reset Timer3 to 0x0000 */
    PR2 = period;           /* assigning Period to PR2 */
    PR3 = period>>16;       /* Period to  PR3 Register */
    T2CON =  config;        /* Configure timer control reg */
    T2CONbits.T32 = 1;
}

#else
#warning "Does not build on this target"
#endif