main.h

PIC C18 读写TLC5628数字电位器程序

#include <18F452.h>
#device adc=8

#FUSES NOWDT                 	//No Watch Dog Timer
#FUSES WDT128                	//Watch Dog Timer uses 1:128 Postscale
#FUSES HS                    	//High speed Osc (> 4mhz)
#FUSES NOPROTECT             	//Code not protected from reading
#FUSES NOOSCSEN              	//Oscillator switching is disabled, main oscillator is source
#FUSES BROWNOUT              	//Reset when brownout detected
#FUSES BORV42                	//Brownout reset at 4.2V
#FUSES NOPUT                 	//No Power Up Timer
#FUSES STVREN                	//Stack full/underflow will cause reset
#FUSES NODEBUG               	//No Debug mode for ICD
#FUSES LVP                   	//Low Voltage Programming on B3(PIC16) or B5(PIC18)
#FUSES NOWRT                 	//Program memory not write protected
#FUSES NOWRTD                	//Data EEPROM not write protected
#FUSES NOWRTB                	//Boot block not write protected
#FUSES NOWRTC                	//configuration not registers write protected
#FUSES NOCPD                 	//No EE protection
#FUSES NOCPB                 	//No Boot Block code protection
#FUSES NOEBTR                	//Memory not protected from table reads
#FUSES NOEBTRB               	//Boot block not protected from table reads

#use delay(clock=20000000)
#define DADATA   PIN_D0
#define DALOAD   PIN_D1
#define LDAC   PIN_D2
#define DACLK   PIN_D6
#define LEDCLK   PIN_D7
#define DSA   PIN_E0
#use rs232(baud=9600,parity=N,xmit=PIN_C6,rcv=PIN_C7,bits=8)