mftphy2500.h.bak

motorola jw32 usb 源码

#include "regssrf04.h"
#define max_channr      0xFF
#define CRC_OK          0x80
#define RSSI            0
#define L_QI            1
#define BYTES_IN_RXFIFO 0xEF
#define WRITE_BURST     0x40
#define READ_SINGLE     0x80
#define READ_BURST      0xC0

//-------------------------------------------------------------------------------------------------------
// RF_SETTINGS is a data structure which contains all relevant CCxxx0 registers
typedef struct S_RF_SETTINGS{
    BYTE FSCTRL1;   // Frequency synthesizer control.
    BYTE FSCTRL0;   // Frequency synthesizer control.
    BYTE FREQ2;     // Frequency control word, high byte.
    BYTE FREQ1;     // Frequency control word, middle byte.
    BYTE FREQ0;     // Frequency control word, low byte.
    BYTE MDMCFG4;   // Modem configuration.
    BYTE MDMCFG3;   // Modem configuration.
    BYTE MDMCFG2;   // Modem configuration.
    BYTE MDMCFG1;   // Modem configuration.
    BYTE MDMCFG0;   // Modem configuration.
    BYTE CHANNR;    // Channel number.
    BYTE DEVIATN;   // Modem deviation setting (when FSK modulation is enabled).
    BYTE FREND1;    // Front end RX configuration.
    BYTE FREND0;    // Front end RX configuration.
    BYTE MCSM0;     // Main Radio Control State Machine configuration.
    BYTE FOCCFG;    // Frequency Offset Compensation Configuration.
    BYTE BSCFG;     // Bit synchronization Configuration.
    BYTE AGCCTRL2;  // AGC control.
    BYTE AGCCTRL0;  // AGC control.
    BYTE FSCAL3;    // Frequency synthesizer calibration.
    BYTE FSCAL2;    // Frequency synthesizer calibration.
    BYTE FSCAL0;    // Frequency synthesizer calibration.
    BYTE FSTEST;    // Frequency synthesizer calibration control
    BYTE TEST2;     // Various test settings.
    BYTE TEST1;     // Various test settings.
    BYTE TEST0;     // Various test settings.
    BYTE IOCFG2;    // GDO2 output pin configuration
    BYTE IOCFG0;    // GDO0 output pin configuration
    BYTE PKTCTRL1;  // Packet automation control.
    BYTE PKTCTRL0;  // Packet automation control.
    BYTE ADDR;      // Device address.
    BYTE PKTLEN;    // Packet length.
} RF_SETTINGS;