wlanup

linux 下的 PCI－RLT8180 driver module

 #--------------------------
 # Load wireless lan driver
 #--------------------------
/sbin/insmod -f rtl8180_24x.o


case "$1" in
 ap)
        echo "ap"
        #------------------------------------------
        # Config AP mode
        # Assign SSID and operation channel.
        #------------------------------------------
        /sbin/iwpriv wlan0 wlan_para ssid=BIAS
        /sbin/iwpriv wlan0 wlan_para channel=2
        ;;
 infra)
        echo "infra"
        #------------------------------------------
        # Config infrastructure mode
        # Assign network type and desired SSID.
        #------------------------------------------
        /sbin/iwpriv wlan0 wlan_para networktype=infra
        /sbin/iwpriv wlan0 wlan_para ssid2scan=NAP_WPA
        ;;
 adhoc)
        echo "adhoc"
        #------------------------------------------
        # Config infrastructure mode
        # Assign network type and desired SSID.
        # 'ssid' and 'channel' are the default setting
        # and meaningful if this is the first station
        # in an IBSS.
        #------------------------------------------
        /sbin/iwpriv wlan0 wlan_para networktype=adhoc
        /sbin/iwpriv wlan0 wlan_para ssid2scan=aaaaa
        /sbin/iwpriv wlan0 wlan_para ssid=A_WPA
        /sbin/iwpriv wlan0 wlan_para channel=2
        ;;
 *)
        /sbin/rmmod rtl8180_24x
        echo "Usage: $0 {ap | infra | adhoc}"
        exit 1
esac




 #--------------------------
 # Config WEP mode
 #--------------------------
/sbin/iwpriv wlan0 wlan_para encmode=off
/sbin/iwpriv wlan0 wlan_para wepmode=off

#/sbin/iwpriv wlan0 wlan_para encmode=wep,wepmode=wep40
#/sbin/iwpriv wlan0 wlan_para wepmode=wep40,wepdkeyid=0,wepkey40_1=1111111111




 #--------------------------
 # Config debugging message
 #--------------------------
/sbin/iwpriv wlan0 msglevel 0




 #--------------------------
 # Enable wireless lan driver
 #--------------------------
/sbin/iwpriv wlan0 enable


 #--------------------------
 # Configure wlan0 IP address
 #--------------------------
/sbin/ifconfig wlan0 192.168.1.180
echo "$(/sbin/ifconfig wlan0)"