armmacros.s

来自「CIRRUS 93XX系列windows mobile 6.0 BSP」· S 代码 · 共 105 行

;/**********************************************************************
;                                                                      
; Filename: ARMMACROS.s
;                                                                      
; Description: macro definitions.
;
; THIS CODE AND INFORMATION IS PROVIDED "AS IS" WITHOUT WARRANTY OF
; ANY KIND, EITHER EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO
; THE IMPLIED WARRANTIES OF MERCHANTABILITY AND/OR FITNESS FOR A
; PARTICULAR PURPOSE.
;
; Use of this source code is subject to the terms of the Cirrus end-user
; license agreement (EULA) under which you licensed this SOFTWARE PRODUCT.
; If you did not accept the terms of the EULA, you are not authorized to 
; use this source code. For a copy of the EULA, please see the 
; EULA.RTF on your install media.
;
; Copyright(c) Cirrus Logic Corporation 2005, All Rights Reserved                       
;                                                                      
;**********************************************************************/

;/**********************************************************************
; Copyright (c) Microsoft Corporation.  All rights reserved.
;
;
; Use of this source code is subject to the terms of the Microsoft end-user
; license agreement (EULA) under which you licensed this SOFTWARE PRODUCT.
; If you did not accept the terms of the EULA, you are not authorized to use
; this source code. For a copy of the EULA, please see the LICENSE.RTF on your
; install media.
;**********************************************************************/

;/***********************************************************************
;  Copyright (c) ARM Limited 1998.  All rights reserved.
;
; NOTE: The CALL and CALLEQ macros shouldn't be used in OS startup code
;       before the MMU is enabled since in the Thumbing case it relies
;       on an absolute address which will be virtual in the case of the
;       OS code and if the MMU isn't enabled, all branches should be
;       relative (or a computed physical address).
;
;***********************************************************************/

  IF Thumbing

    MACRO
    CALL $Fn
    ldr     r12, =$Fn
    mov     lr, pc
    bx      r12
    MEND

    MACRO
    CALLEQ $Fn
    ldreq   r12, =$Fn
    moveq   lr, pc
    bxeq    r12
    MEND

    MACRO
    RETURN
    bx      lr
    MEND

    MACRO
    RETURN_EQ
    bxeq    lr
    MEND

    MACRO
    RETURN_NE
    bxne    lr
    MEND

  ELSE

    MACRO
    CALL $Fn
    bl      $Fn
    MEND

    MACRO
    CALLEQ $Fn
    bleq    $Fn
    MEND

    MACRO
    RETURN
    mov     pc, lr
    MEND

    MACRO
    RETURN_EQ
    moveq   pc, lr
    MEND

    MACRO
    RETURN_NE
    movne   pc, lr
    MEND

  ENDIF

    END