config.in

老版本的mtd-snap

# drivers/mtd/maps/Config.in

# $Id: Config.in,v 1.72 2005/02/27 21:50:21 ppopov Exp $

mainmenu_option next_comment

comment 'Mapping drivers for chip access'

bool '  Support for non-linear mappings of flash chips' CONFIG_MTD_COMPLEX_MAPPINGS

bool '  CFI Flash device in physical memory map' CONFIG_MTD_PHYSMAP $CONFIG_MTD_GEN_PROBE
if [ "$CONFIG_MTD_PHYSMAP" = "y" ]; then
   hex '    Physical start address of flash mapping' CONFIG_MTD_PHYSMAP_START 0x8000000
   hex '    Physical length of flash mapping' CONFIG_MTD_PHYSMAP_LEN 0x4000000
   int '    Bank width in octets' CONFIG_MTD_PHYSMAP_BANKWIDTH 2
fi

if [ "$CONFIG_SPARC" = "y" -o "$CONFIG_SPARC64" = "y" ]; then
   dep_tristate '  Sun Microsystems userflash support' CONFIG_MTD_SUN_UFLASH $CONFIG_MTD_CFI
fi

if [ "$CONFIG_X86" = "y" ]; then
   dep_tristate '  CFI Flash device mapped on Photron PNC-2000' CONFIG_MTD_PNC2000 $CONFIG_MTD_CFI $CONFIG_MTD_PARTITIONS
   dep_tristate '  CFI Flash device mapped on AMD SC520 CDP' CONFIG_MTD_SC520CDP $CONFIG_MTD_CFI
   dep_tristate '  CFI Flash device mapped on AMD NetSc520'  CONFIG_MTD_NETSC520 $CONFIG_MTD_CFI $CONFIG_MTD_PARTITIONS
   dep_tristate '  CFI Flash device mapped on Arcom SBC-GXx boards' CONFIG_MTD_SBC_GXX $CONFIG_MTD_CFI_INTELEXT $CONFIG_MTD_PARTITIONS $CONFIG_MTD_COMPLEX_MAPPINGS
   dep_tristate '  CFI Flash device mapped on Arcom ELAN-104NC' CONFIG_MTD_ELAN_104NC $CONFIG_MTD_CFI_INTELEXT $CONFIG_MTD_PARTITIONS $CONFIG_MTD_COMPLEX_MAPPINGS
   dep_tristate '  CFI Flash device mapped on DIL/Net PC' CONFIG_MTD_DILNETPC $CONFIG_MTD_CFI_INTELEXT $CONFIG_MTD_PARTITIONS $CONFIG_MTD_CONCAT
   if [ "$CONFIG_MTD_DILNETPC" = "y" -o "$CONFIG_MTD_DILNETPC" = "m" ]; then
     hex '    Size of boot partition' CONFIG_MTD_DILNETPC_BOOTSIZE 0x80000
   fi
   dep_tristate '  JEDEC Flash device mapped on Octagon 5066 SBC' CONFIG_MTD_OCTAGON $CONFIG_MTD_JEDEC $CONFIG_MTD_COMPLEX_MAPPINGS
   dep_tristate '  JEDEC Flash device mapped on Tempustech VMAX SBC301' CONFIG_MTD_VMAX $CONFIG_MTD_JEDEC $CONFIG_MTD_COMPLEX_MAPPINGS
   dep_tristate '  Flash device mapped with DOCCS on NatSemi SCx200' CONFIG_MTD_SCx200_DOCFLASH $CONFIG_MTD_CFI
   dep_tristate '  BIOS flash chip on Intel L440GX boards' CONFIG_MTD_L440GX $CONFIG_MTD_JEDECPROBE
   dep_tristate '  ROM connected to AMD76X southbridge' CONFIG_MTD_AMD76XROM $CONFIG_MTD_GEN_PROBE   
   dep_tristate '  ROM connected to Intel Hub Controller 2/3/4/5' CONFIG_MTD_ICHXROM $CONFIG_MTD_JEDECPROBE
   dep_tristate '  CFI Flash device mapped on SnapGear/SecureEdge' CONFIG_MTD_NETtel $CONFIG_MTD_PARTITIONS
   dep_tristate '  BIOS flash chip on Intel SCB2 boards' CONFIG_MTD_SCB2_FLASH $CONFIG_MTD_GEN_PROBE
fi

if [ "$CONFIG_PPC32" = "y" ]; then
  if [ "$CONFIG_6xx" = "y" -a "$CONFIG_8260" = "y" ]; then
    dep_tristate '  Flash device on SBC8240' CONFIG_MTD_SBC8240 $CONFIG_MTD_JEDECPROBE
  fi
  if [ "$CONFIG_8xx" = "y" ]; then
    if [ "$CONFIG_TQM8xxL" = "y" ]; then
      dep_tristate '  CFI Flash device mapped on TQM8XXL' CONFIG_MTD_TQM8XXL $CONFIG_MTD_CFI
    fi
    if [ "$CONFIG_RPXLITE" = "y" -o "$CONFIG_RPXCLASSIC" = "y" ]; then
      dep_tristate '  CFI Flash device mapped on RPX Lite or CLLF' CONFIG_MTD_RPXLITE $CONFIG_MTD_CFI
    fi
    if [ "$CONFIG_MBX" = "y" ]; then
      dep_tristate '  System flash on MBX860 board' CONFIG_MTD_MBX860 $CONFIG_MTD_CFI
    fi
    if [ "$CONFIG_DBOX2" = "y" ]; then
      dep_tristate '  CFI Flash device mapped on D-Box2' CONFIG_MTD_DBOX2 $CONFIG_MTD_CFI
    fi
    dep_tristate '  CFI Flash device mapping on FlagaDM' CONFIG_MTD_CFI_FLAGADM $CONFIG_MTD_CFI
  fi
  if [ "$CONFIG_4xx" = "y" ]; then
    if [ "$CONFIG_40x" = "y" ]; then
      if [ "$CONFIG_REDWOOD_4" = "y" -o "$CONFIG_REDWOOD_5" = "y" -o "$CONFIG_REDWOOD_6" = "y" ]; then
        dep_tristate '  CFI Flash device mapped on IBM Redwood' CONFIG_MTD_REDWOOD $CONFIG_MTD_CFI
      fi
      dep_tristate '  CFI Flash device mapped on IBM Beech' CONFIG_MTD_BEECH $CONFIG_MTD_CFI $CONFIG_BEECH
      dep_tristate '  CFI Flash device mapped on IBM Arctic' CONFIG_MTD_ARCTIC $CONFIG_MTD_CFI $CONFIG_ARCTIC2
      dep_tristate '  Flash device mapped on IBM Walnut' CONFIG_MTD_WALNUT $CONFIG_MTD_JEDECPROBE $CONFIG_WALNUT
    fi
    if [ "$CONFIG_440" = "y" ]; then
      dep_tristate '  Flash devices mapped on IBM Ebony' CONFIG_MTD_EBONY $CONFIG_MTD_JEDECPROBE $CONFIG_EBONY
    fi
  fi
fi

if [ "$CONFIG_MIPS" = "y" -o "$CONFIG_MIPS64" = "y" ]; then
   dep_tristate '  AMD Alchemy Pb1xxx/Db1xxx/RDK MTD support' CONFIG_MTD_ALCHEMY $CONFIG_SOC_AU1X00
   dep_tristate '  Flash chip mapping on ITE QED-4N-S01B, Globespan IVR or custom board' CONFIG_MTD_CSTM_MIPS_IXX $CONFIG_MTD_CFI $CONFIG_MTD_JEDEC $CONFIG_MTD_PARTITIONS 
   if [ "$CONFIG_MTD_CSTM_MIPS_IXX" = "y" -o "$CONFIG_MTD_CSTM_MIPS_IXX" = "m" ]; then
      hex '    Physical start address of flash mapping' CONFIG_MTD_CSTM_MIPS_IXX_START 0x8000000
      hex '    Physical length of flash mapping' CONFIG_MTD_CSTM_MIPS_IXX_LEN 0x4000000
      int '    Bus width in octets' CONFIG_MTD_CSTM_MIPS_IXX_BUSWIDTH 2
   fi
   dep_tristate '  Momenco Ocelot boot flash device' CONFIG_MTD_OCELOT $CONFIG_MOMENCO_OCELOT
   dep_tristate '  LASAT flash device' CONFIG_MTD_LASAT $CONFIG_LASAT
fi

if [ "$CONFIG_SUPERH" = "y" ]; then
   dep_tristate '  CFI Flash device mapped on Hitachi SolutionEngine' \
      CONFIG_MTD_SOLUTIONENGINE $CONFIG_MTD_PARTITIONS $CONFIG_MTD_CFI
   if [ "$CONFIG_MTD_SOLUTIONENGINE" != "n" ]; then
      hex '  Default reserved Flash size'  CONFIG_MTD_SUPERH_RESERVE 0x00010000
   fi
fi

if [ "$CONFIG_ARM" = "y" ]; then
   dep_tristate '  CFI Flash device mapped on ARM Integrator/P720T' CONFIG_MTD_ARM_INTEGRATOR $CONFIG_MTD_CFI
   dep_tristate '  Cirrus CDB89712 evaluation board mappings' CONFIG_MTD_CDB89712 $CONFIG_MTD_CFI $CONFIG_ARCH_CDB89712
   dep_tristate '  CFI Flash device mapped on StrongARM SA11x0' CONFIG_MTD_SA1100 $CONFIG_MTD_CFI $CONFIG_ARCH_SA1100 $CONFIG_MTD_PARTITIONS
   dep_tristate '  CFI Flash device mapped on DC21285 Footbridge' CONFIG_MTD_DC21285 $CONFIG_MTD_CFI $CONFIG_ARCH_FOOTBRIDGE $CONFIG_MTD_COMPLEX_MAPPINGS
   dep_tristate '  CFI Flash device mapped on the XScale IQ80310 board' CONFIG_MTD_IQ80310 $CONFIG_MTD_CFI $CONFIG_ARCH_IQ80310
   dep_tristate '  CFI Flash device mapped on the XScale Lubbock board' CONFIG_MTD_LUBBOCK $CONFIG_MTD_CFI $CONFIG_ARCH_LUBBOCK
   dep_tristate '  CFI Flash device mapped on XScale IXP425 systems' CONFIG_MTD_IXP425 $CONFIG_MTD_CFI $CONFIG_MTD_COMPLEX_MAPPINGS 
   dep_tristate '  CFI Flash device mapped on Epxa10db' CONFIG_MTD_EPXA10DB $CONFIG_MTD_CFI  $CONFIG_MTD_PARTITIONS $CONFIG_ARCH_CAMELOT
   dep_tristate '  CFI Flash device mapped on the FortuNet board' CONFIG_MTD_FORTUNET $CONFIG_MTD_CFI $CONFIG_MTD_PARTITIONS $CONFIG_SA1100_FORTUNET
   dep_tristate '  NV-RAM mapping AUTCPU12 board' CONFIG_MTD_AUTCPU12 $CONFIG_ARCH_AUTCPU12
   dep_tristate '  CFI Flash device mapped on EDB7312' CONFIG_MTD_EDB7312 $CONFIG_MTD_CFI
   dep_tristate '  CFI Flash device mapped on Hynix evaluation boards' CONFIG_MTD_H720X $CONFIG_MTD_CFI
   dep_tristate '  JEDEC Flash device mapped on impA7' CONFIG_MTD_IMPA7 $CONFIG_MTD_JEDECPROBE
   dep_tristate '  JEDEC Flash device mapped on Ceiva/Polaroid PhotoMax Digital Picture Frame' CONFIG_MTD_CEIVA $CONFIG_MTD_JEDECPROBE  $CONFIG_ARCH_CEIVA
   dep_tristate '  NOR Flash device on TOTO board' CONFIG_MTD_NOR_TOTO $CONFIG_MTD $CONFIG_OMAP_TOTO
fi
if [ "$CONFIG_ALPHA" = "y" ]; then
   dep_tristate '  Flash chip mapping on TSUNAMI' CONFIG_MTD_TSUNAMI $CONFIG_MTD_GENPROBE $CONFIG_MTD_COMPLEX_MAPPINGS
fi

if [ "$CONFIG_UCLINUX" = "y" ]; then
   dep_tristate '  Generic uClinux RAM/ROM filesystem support' CONFIG_MTD_UCLINUX $CONFIG_MTD_PARTITIONS
fi

# This needs CFI or JEDEC, depending on the cards found.
dep_tristate '  PCI MTD driver' CONFIG_MTD_PCI $CONFIG_MTD $CONFIG_PCI $CONFIG_MTD_COMPLEX_MAPPINGS
dep_tristate '  PCMCIA MTD driver' CONFIG_MTD_PCMCIA $CONFIG_MTD $CONFIG_PCMCIA $CONFIG_MTD_COMPLEX_MAPPINGS

endmenu