⭐ 欢迎来到虫虫下载站! | 📦 资源下载 📁 资源专辑 ℹ️ 关于我们
⭐ 虫虫下载站

📄 cs5535audio_pm.c

📁 linux 内核源代码
💻 C
字号:
/* * Power management for audio on multifunction CS5535 companion device * Copyright (C) Jaya Kumar * * This program is free software; you can redistribute it and/or modify * it under the terms of the GNU General Public License as published by * the Free Software Foundation; either version 2 of the License, or * (at your option) any later version. * * This program is distributed in the hope that it will be useful, * but WITHOUT ANY WARRANTY; without even the implied warranty of * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the * GNU General Public License for more details. * * You should have received a copy of the GNU General Public License * along with this program; if not, write to the Free Software * Foundation, Inc., 59 Temple Place, Suite 330, Boston, MA  02111-1307 USA * */#include <linux/init.h>#include <linux/slab.h>#include <linux/pci.h>#include <linux/delay.h>#include <sound/driver.h>#include <sound/core.h>#include <sound/control.h>#include <sound/initval.h>#include <sound/asoundef.h>#include <sound/pcm.h>#include <sound/ac97_codec.h>#include "cs5535audio.h"static void snd_cs5535audio_stop_hardware(struct cs5535audio *cs5535au){	/* 	we depend on snd_ac97_suspend to tell the	AC97 codec to shutdown. the amd spec suggests	that the LNK_SHUTDOWN be done at the same time	that the codec power-down is issued. instead,	we do it just after rather than at the same 	time. excluding codec specific build_ops->suspend	ac97 powerdown hits:	0x8000 EAPD 	0x4000 Headphone amplifier 	0x0300 ADC & DAC 	0x0400 Analog Mixer powerdown (Vref on) 	I am not sure if this is the best that we can do.	The remainder to be investigated are:	- analog mixer (vref off) 0x0800	- AC-link powerdown 0x1000	- codec internal clock 0x2000	*/	/* set LNK_SHUTDOWN to shutdown AC link */	cs_writel(cs5535au, ACC_CODEC_CNTL, ACC_CODEC_CNTL_LNK_SHUTDOWN);}int snd_cs5535audio_suspend(struct pci_dev *pci, pm_message_t state){	struct snd_card *card = pci_get_drvdata(pci);	struct cs5535audio *cs5535au = card->private_data;	int i;	snd_power_change_state(card, SNDRV_CTL_POWER_D3hot);	snd_pcm_suspend_all(cs5535au->pcm);	snd_ac97_suspend(cs5535au->ac97);	for (i = 0; i < NUM_CS5535AUDIO_DMAS; i++) {		struct cs5535audio_dma *dma = &cs5535au->dmas[i];		if (dma && dma->substream)			dma->saved_prd = dma->ops->read_prd(cs5535au);	}	/* save important regs, then disable aclink in hw */	snd_cs5535audio_stop_hardware(cs5535au);	if (pci_save_state(pci)) {		printk(KERN_ERR "cs5535audio: pci_save_state failed!\n");		return -EIO;	}	pci_disable_device(pci);	pci_set_power_state(pci, pci_choose_state(pci, state));	return 0;}int snd_cs5535audio_resume(struct pci_dev *pci){	struct snd_card *card = pci_get_drvdata(pci);	struct cs5535audio *cs5535au = card->private_data;	u32 tmp;	int timeout;	int i;	pci_set_power_state(pci, PCI_D0);	if (pci_restore_state(pci) < 0) {		printk(KERN_ERR "cs5535audio: pci_restore_state failed, "		       "disabling device\n");		snd_card_disconnect(card);		return -EIO;	}	if (pci_enable_device(pci) < 0) {		printk(KERN_ERR "cs5535audio: pci_enable_device failed, "		       "disabling device\n");		snd_card_disconnect(card);		return -EIO;	}	pci_set_master(pci);	/* set LNK_WRM_RST to reset AC link */	cs_writel(cs5535au, ACC_CODEC_CNTL, ACC_CODEC_CNTL_LNK_WRM_RST);	timeout = 50;	do {		tmp = cs_readl(cs5535au, ACC_CODEC_STATUS);		if (tmp & PRM_RDY_STS)			break;		udelay(1);	} while (--timeout);	if (!timeout)		snd_printk(KERN_ERR "Failure getting AC Link ready\n");	/* set up rate regs, dma. actual initiation is done in trig */	for (i = 0; i < NUM_CS5535AUDIO_DMAS; i++) {		struct cs5535audio_dma *dma = &cs5535au->dmas[i];		if (dma && dma->substream) {			dma->substream->ops->prepare(dma->substream);			dma->ops->setup_prd(cs5535au, dma->saved_prd);		}	}	/* we depend on ac97 to perform the codec power up */	snd_ac97_resume(cs5535au->ac97);	snd_power_change_state(card, SNDRV_CTL_POWER_D0);	return 0;}

⌨️ 快捷键说明

复制代码 Ctrl + C
搜索代码 Ctrl + F
全屏模式 F11
切换主题 Ctrl + Shift + D
显示快捷键 ?
增大字号 Ctrl + =
减小字号 Ctrl + -