cc1000squelch.nc

来自「tinyos-2.0源代码！转载而已！要的尽管拿！」· NC 代码 · 共 55 行

/* $Id: CC1000Squelch.nc,v 1.1.2.2 2006/01/26 21:11:40 idgay Exp $
 * "Copyright (c) 2000-2005 The Regents of the University  of California.  
 * All rights reserved.
 *
 * Permission to use, copy, modify, and distribute this software and its
 * documentation for any purpose, without fee, and without written agreement is
 * hereby granted, provided that the above copyright notice, the following
 * two paragraphs and the author appear in all copies of this software.
 * 
 * IN NO EVENT SHALL THE UNIVERSITY OF CALIFORNIA BE LIABLE TO ANY PARTY FOR
 * DIRECT, INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES ARISING OUT
 * OF THE USE OF THIS SOFTWARE AND ITS DOCUMENTATION, EVEN IF THE UNIVERSITY OF
 * CALIFORNIA HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
 * 
 * THE UNIVERSITY OF CALIFORNIA SPECIFICALLY DISCLAIMS ANY WARRANTIES,
 * INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY
 * AND FITNESS FOR A PARTICULAR PURPOSE.  THE SOFTWARE PROVIDED HEREUNDER IS
 * ON AN "AS IS" BASIS, AND THE UNIVERSITY OF CALIFORNIA HAS NO OBLIGATION TO
 * PROVIDE MAINTENANCE, SUPPORT, UPDATES, ENHANCEMENTS, OR MODIFICATIONS."
 *
 * Copyright (c) 2002-2005 Intel Corporation
 * All rights reserved.
 *
 * This file is distributed under the terms in the attached INTEL-LICENSE     
 * file. If you do not find these files, copies can be found by writing to
 * Intel Research Berkeley, 2150 Shattuck Avenue, Suite 1300, Berkeley, CA, 
 * 94704.  Attention:  Intel License Inquiry.
 */

/**
 * CC1000 internal noise floor (aka squelch value) interface
 * @author David Gay
 */
interface CC1000Squelch
{
  /**
   * Adjust noise floor based on new noise measurement
   * @param data noise measurement
   */
  command void adjust(uint16_t data);

  /**
   * Return current estimated noise floor
   * @return Noise floor value
   */
  async command uint16_t get();

  /**
   * Check if noise floor estimate is considered stable (typically after
   * some number of measurements)
   * @return TRUE if noise floor estimate considered stable, FALSE otherwise
   */
  command bool settled();
}