sd_driver.c

STM32的SD卡驱动及液晶驱动源代码资料

/*****************************************************\
*河南工业大学Freescale MCU&DSP联合实验室
*文 件 名：9325_FW.h
*C  P  U ：MC9S08AW60
*调试环境：CodeWarrior 6.0 
*作    者：曾 滔
*描    述: 9325液晶屏方案框架
*日    期：2008年8月29日
\*****************************************************/


/* Includes ------------------------------------------------------------------*/
#include "SD_Driver.h"

void SD_IO_Init(void)
{
  SPI_InitTypeDef  SPI_InitStructure;
  GPIO_InitTypeDef GPIO_InitStructure;
   
  /* Enable SPI1 and GPIOA clocks */
  RCC_APB2PeriphClockCmd(RCC_APB2Periph_SPI1 | RCC_APB2Periph_GPIOA, ENABLE);
  
  /* Configure SPI1 pins: NSS, SCK, MISO and MOSI */
  GPIO_InitStructure.GPIO_Pin = GPIO_Pin_5 | GPIO_Pin_6 | GPIO_Pin_7;
  GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;
  GPIO_InitStructure.GPIO_Mode = GPIO_Mode_AF_PP;
  GPIO_Init(GPIOA, &GPIO_InitStructure);

  /* Configure  as Output push-pull, used as SD CS&PWR*/
  GPIO_InitStructure.GPIO_Pin = GPIO_Pin_9 | GPIO_Pin_10;
  GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;
  GPIO_InitStructure.GPIO_Mode = GPIO_Mode_Out_PP;
  GPIO_Init(GPIOD, &GPIO_InitStructure);

  SPI_FLASH_PWR_ON();
  SPI_FLASH_CS_HIGH();

  /* SPI1 configuration */ 
  SPI_InitStructure.SPI_Direction = SPI_Direction_2Lines_FullDuplex;
  SPI_InitStructure.SPI_Mode = SPI_Mode_Master;
  SPI_InitStructure.SPI_DataSize = SPI_DataSize_8b;
  SPI_InitStructure.SPI_CPOL = SPI_CPOL_High;
  SPI_InitStructure.SPI_CPHA = SPI_CPHA_2Edge;
  SPI_InitStructure.SPI_NSS = SPI_NSS_Soft;
  SPI_InitStructure.SPI_BaudRatePrescaler = SPI_BaudRatePrescaler_4;
  SPI_InitStructure.SPI_FirstBit = SPI_FirstBit_MSB;
  SPI_InitStructure.SPI_CRCPolynomial = 7;
  SPI_Init(SPI1, &SPI_InitStructure);
  
  /* Enable SPI1  */
  SPI_Cmd(SPI1, ENABLE);   
}