idcontrol.h

来自「基于凌阳单片机的简单的工业顺序控制」· C头文件 代码 · 共 33 行

#ifndef	__IDCONTROL_H__
#define	__IDCONTROL_H__
//	write your header here
#define P_IOA_Data 			(volatile unsigned int *)0x7000   
#define P_IOA_Dir 			(volatile unsigned int *)0x7002
#define P_IOA_Attrib 		(volatile unsigned int *)0x7003
#define P_IOB_Data			(volatile unsigned int *)0x7005  
#define P_IOB_Dir			(volatile unsigned int *)0x7007   
#define P_IOB_Attrib			(volatile unsigned int *)0x7008   
#define P_TimerA_Data		(volatile unsigned int *)0x700A   
#define P_TimerA_Ctrl		(volatile unsigned int *)0x700B   
#define P_TimerB_Data		(volatile unsigned int *)0x700C   
#define P_TimerB_Ctrl		(volatile unsigned int *)0x700D
#define P_Watchdog_Clear		(volatile unsigned int *)0x7012
#define P_INT_Clear			(volatile unsigned int *)0x7011
#define P_INT_Mask			(volatile unsigned int *)0x702D


#define NAME_ID 				0x100
#define COMMAND_START_ID		0X101
#define COMMAND_OK_ID 			0x102
#define S_NAME				0			//给我取个名字吧
#define S_ACT1				1			//“开始”--程序开始
#define S_ACT2				2			//“继续”--故障已排除
#define S_TEMP				3			//YEAH
#define S_AGAIN				4			//请再说一遍
#define S_NOVOICE			5			//没有听到任何声音
#define S_CMDDIFF			6			//两次输入命令不同
#define S_NOISY				7		//太吵了
#define S_START				8			//准备就绪，开始辨识
#define S_POLICE			9			//报警	
#endif