📄 zls_cc2500.h
字号:
/***********************************************************************************
Filename: cc2500.h
Copyright 2007 Texas Instruments, Inc.
***********************************************************************************/
#ifndef CC2500_H
#define CC2500_H
#include <hal_types.h>
// Configuration Registers
#define CC2500_IOCFG2 0x00 // GDO2 output pin configuration
#define CC2500_IOCFG1 0x01 // GDO1 output pin configuration
#define CC2500_IOCFG0 0x02 // GDO0 output pin configuration
#define CC2500_FIFOTHR 0x03 // RX FIFO and TX FIFO thresholds
#define CC2500_SYNC1 0x04 // Sync word, high byte
#define CC2500_SYNC0 0x05 // Sync word, low byte
#define CC2500_PKTLEN 0x06 // Packet length
#define CC2500_PKTCTRL1 0x07 // Packet automation control
#define CC2500_PKTCTRL0 0x08 // Packet automation control
#define CC2500_ADDR 0x09 // Device address
#define CC2500_CHANNR 0x0A // Channel number
#define CC2500_FSCTRL1 0x0B // Frequency synthesizer control
#define CC2500_FSCTRL0 0x0C // Frequency synthesizer control
#define CC2500_FREQ2 0x0D // Frequency control word, high byte
#define CC2500_FREQ1 0x0E // Frequency control word, middle byte
#define CC2500_FREQ0 0x0F // Frequency control word, low byte
#define CC2500_MDMCFG4 0x10 // Modem configuration
#define CC2500_MDMCFG3 0x11 // Modem configuration
#define CC2500_MDMCFG2 0x12 // Modem configuration
#define CC2500_MDMCFG1 0x13 // Modem configuration
#define CC2500_MDMCFG0 0x14 // Modem configuration
#define CC2500_DEVIATN 0x15 // Modem deviation setting
#define CC2500_MCSM2 0x16 // Main Radio Cntrl State Machine config
#define CC2500_MCSM1 0x17 // Main Radio Cntrl State Machine config
#define CC2500_MCSM0 0x18 // Main Radio Cntrl State Machine config
#define CC2500_FOCCFG 0x19 // Frequency Offset Compensation config
#define CC2500_BSCFG 0x1A // Bit Synchronization configuration
#define CC2500_AGCCTRL2 0x1B // AGC control
#define CC2500_AGCCTRL1 0x1C // AGC control
#define CC2500_AGCCTRL0 0x1D // AGC control
#define CC2500_WOREVT1 0x1E // High byte Event 0 timeout
#define CC2500_WOREVT0 0x1F // Low byte Event 0 timeout
#define CC2500_WORCTRL 0x20 // Wake On Radio control
#define CC2500_FREND1 0x21 // Front end RX configuration
#define CC2500_FREND0 0x22 // Front end TX configuration
#define CC2500_FSCAL3 0x23 // Frequency synthesizer calibration
#define CC2500_FSCAL2 0x24 // Frequency synthesizer calibration
#define CC2500_FSCAL1 0x25 // Frequency synthesizer calibration
#define CC2500_FSCAL0 0x26 // Frequency synthesizer calibration
#define CC2500_RCCTRL1 0x27 // RC oscillator configuration
#define CC2500_RCCTRL0 0x28 // RC oscillator configuration
#define CC2500_FSTEST 0x29 // Frequency synthesizer cal control
#define CC2500_PTEST 0x2A // Production test
#define CC2500_AGCTEST 0x2B // AGC test
#define CC2500_TEST2 0x2C // Various test settings
#define CC2500_TEST1 0x2D // Various test settings
#define CC2500_TEST0 0x2E // Various test settings
// Status registers
#define CC2500_PARTNUM 0x30 // Part number
#define CC2500_VERSION 0x31 // Current version number
#define CC2500_FREQEST 0x32 // Frequency offset estimate
#define CC2500_LQI 0x33 // Demodulator estimate for link quality
#define CC2500_RSSI 0x34 // Received signal strength indication
#define CC2500_MARCSTATE 0x35 // Control state machine state
#define CC2500_WORTIME1 0x36 // High byte of WOR timer
#define CC2500_WORTIME0 0x37 // Low byte of WOR timer
#define CC2500_PKTSTATUS 0x38 // Current GDOx status and packet status
#define CC2500_VCO_VC_DAC 0x39 // Current setting from PLL cal module
#define CC2500_TXBYTES 0x3A // Underflow and # of bytes in TXFIFO
#define CC2500_RXBYTES 0x3B // Overflow and # of bytes in RXFIFO
// Multi byte memory locations
#define CC2500_PATABLE 0x3E
#define CC2500_TXFIFO 0x3F
#define CC2500_RXFIFO 0x3F
// Definitions for burst/single access to registers
#define CC2500_WRITE_BURST 0x40
#define CC2500_READ_SINGLE 0x80
#define CC2500_READ_BURST 0xC0
// Strobe commands
#define CC2500_SRES 0x30 // Reset chip.
#define CC2500_SFSTXON 0x31 // Enable and calibrate frequency synthesizer (if MCSM0.FS_AUTOCAL=1).
// If in RX/TX: Go to a wait state where only the synthesizer is
// running (for quick RX / TX turnaround).
#define CC2500_SXOFF 0x32 // Turn off crystal oscillator.
#define CC2500_SCAL 0x33 // Calibrate frequency synthesizer and turn it off
// (enables quick start).
#define CC2500_SRX 0x34 // Enable RX. Perform calibration first if coming from IDLE and
// MCSM0.FS_AUTOCAL=1.
#define CC2500_STX 0x35 // In IDLE state: Enable TX. Perform calibration first if
// MCSM0.FS_AUTOCAL=1. If in RX state and CCA is enabled:
// Only go to TX if channel is clear.
#define CC2500_SIDLE 0x36 // Exit RX / TX, turn off frequency synthesizer and exit
// Wake-On-Radio mode if applicable.
#define CC2500_SAFC 0x37 // Perform AFC adjustment of the frequency synthesizer
#define CC2500_SWOR 0x38 // Start automatic RX polling sequence (Wake-on-Radio)
#define CC2500_SPWD 0x39 // Enter power down mode when CSn goes high.
#define CC2500_SFRX 0x3A // Flush the RX FIFO buffer.
#define CC2500_SFTX 0x3B // Flush the TX FIFO buffer.
#define CC2500_SWORRST 0x3C // Reset real time clock.
#define CC2500_SNOP 0x3D // No operation. May be used to pad strobe commands to two
// bytes for simpler software.
//----------------------------------------------------------------------------------
// Chip Status Byte
//----------------------------------------------------------------------------------
// Bit fields in the chip status byte
#define CC2500_STATUS_CHIP_RDYn_BM 0x80
#define CC2500_STATUS_STATE_BM 0x70
#define CC2500_STATUS_FIFO_BYTES_AVAILABLE_BM 0x0F
// Chip states
#define CC2500_STATE_IDLE 0x00
#define CC2500_STATE_RX 0x10
#define CC2500_STATE_TX 0x20
#define CC2500_STATE_FSTXON 0x30
#define CC2500_STATE_CALIBRATE 0x40
#define CC2500_STATE_SETTLING 0x50
#define CC2500_STATE_RX_OVERFLOW 0x60
#define CC2500_STATE_TX_UNDERFLOW 0x70
//----------------------------------------------------------------------------------
// Other register bit fields
//----------------------------------------------------------------------------------
#define CC2500_LQI_CRC_OK_BM 0x80
#define CC2500_LQI_EST_BM 0x7F
/**********************************************************************************/
#endif
⌨️ 快捷键说明
复制代码
Ctrl + C
搜索代码
Ctrl + F
全屏模式
F11
切换主题
Ctrl + Shift + D
显示快捷键
?
增大字号
Ctrl + =
减小字号
Ctrl + -