makefile

madwifi上的atheros无线网卡驱动源码

#
# Copyright (c) 2002-2005 Sam Leffler, Errno Consulting
# All rights reserved.
#
# Redistribution and use in source and binary forms, with or without
# modification, are permitted provided that the following conditions
# are met:
# 1. Redistributions of source code must retain the above copyright
#    notice, this list of conditions and the following disclaimer,
#    without modification.
# 2. Redistributions in binary form must reproduce at minimum a disclaimer
#    similar to the "NO WARRANTY" disclaimer below ("Disclaimer") and any
#    redistribution must be conditioned upon including a substantially
#    similar Disclaimer requirement for further binary redistribution.
# 3. Neither the names of the above-listed copyright holders nor the names
#    of any contributors may be used to endorse or promote products derived
#    from this software without specific prior written permission.
#
# Alternatively, this software may be distributed under the terms of the
# GNU General Public License ("GPL") version 2 as published by the Free
# Software Foundation.
#
# NO WARRANTY
# THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
# ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
# LIMITED TO, THE IMPLIED WARRANTIES OF NONINFRINGEMENT, MERCHANTIBILITY
# AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL
# THE COPYRIGHT HOLDERS OR CONTRIBUTORS BE LIABLE FOR SPECIAL, EXEMPLARY,
# OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF
# SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS
# INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER
# IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
# ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF
# THE POSSIBILITY OF SUCH DAMAGES.
#
# $Id: //depot/sw/linuxsrc/src/802_11/madwifi/madwifi/Makefile $
#

#
# Makefile for the HAL-based Atheros driver.
#

ifeq ($(obj),)
obj=	.
endif

TOP = $(obj)

ifneq (svnversion.h,$(MAKECMDGOALS))
include $(TOP)/Makefile.inc
endif

obj-y := ath/ ath_hal/ ath_rate/ net80211/

all: modules tools

modules: configcheck svnversion.h
ifdef LINUX24
	for i in $(obj-y); do \
		$(MAKE) -C $$i || exit 1; \
	done
else
	$(MAKE) -C $(KERNELPATH) SUBDIRS=$(shell pwd) modules
endif

.PHONY: svnversion.h
svnversion.h:
	@if [ -d .svn ]; then \
		ver=`svnversion -nc . | sed -e 's/^[^:]*://;s/[A-Za-z]//'`; \
		echo "#define SVNVERSION \"svn r$$ver\"" > $@.tmp; \
	elif [ -s SNAPSHOT ]; then \
		ver=`sed -e '/^Revision: */!d;s///;q' SNAPSHOT`; \
		echo "#define SVNVERSION \"svn r$$ver\"" > $@.tmp; \
	else \
		touch $@.tmp; \
	fi; \
	diff $@ $@.tmp >/dev/null 2>&1 || cp -f $@.tmp $@; rm -f $@.tmp

# conflicts with the 'tools' subdirectory
.PHONY: tools
tools:
	$(MAKE) -C $(TOOLS) all || exit 1

install: install-modules install-tools

install-modules:
	@# check if there are modules left from an old installation
	@# might cause make to abort the build
	sh scripts/find-madwifi-modules.sh $(KERNELRELEASE) $(DESTDIR)

	for i in $(obj-y); do \
		$(MAKE) -C $$i install || exit 1; \
	done
ifeq ($(DESTDIR),)
	(export KMODPATH=$(KMODPATH); /sbin/depmod -ae $(KERNELRELEASE))
endif

install-tools:
	$(MAKE) -C $(TOOLS) install || exit 1

uninstall:
	sh scripts/find-madwifi-modules.sh $(KERNELRELEASE) $(DESTDIR)
	$(MAKE) -C $(TOOLS) uninstall

clean:
	for i in $(obj-y); do \
		$(MAKE) -C $$i clean; \
	done
	-$(MAKE) -C $(TOOLS) clean
	rm -rf .tmp_versions
	rm -f *.symvers svnversion.h

info:
	@echo "The following settings will be used for compilation:"
	@echo "TARGET       : $(TARGET)"
	@echo "ARCH         : $(ARCH)"
	@echo "BUS          : $(BUS)"
	@if [ -n "$(TOOLPATH)" ]; then \
	    @echo "TOOLPATH     : $(TOOLPATH)"; \
	fi	
	@echo "KERNELRELEASE: $(KERNELRELEASE)"
	@echo "KERNELPATH   : $(KERNELPATH)"
	@echo "KERNELCONF   : $(KERNELCONF)"
	@echo "KMODPATH     : $(KMODPATH)"
	@echo "KMODSUF      : $(KMODSUF)"

sanitycheck:
	@echo -n "Checking requirements... "
	
	@# check if specified rate control is available
	@if [ ! -d $(ATH_RATE) ]; then \
	    echo "FAILED"; \
	    echo "Selected rate control $(ATH_RATE) not available."; \
	    exit 1; \
	fi
	
	@echo "ok."

.PHONY: release
release:
	sh scripts/make-release.bash

configcheck: sanitycheck
	@echo -n "Checking kernel configuration... "
	
	@# check version of kernel
	@echo $(KERNELRELEASE) | grep -q -i '^[2-9]\.[4-9]\.' || { \
	    echo "FAILED"; \
	    echo "Only kernel versions 2.4.x and above are supported."; \
	    echo "You have $(KERNELRELEASE)."; \
	    exit 1; \
	}
	
	@# check kernel configuration
	@if [ -z "$(CONFIG_SYSCTL)" ]; then \
	    echo "FAILED"; \
	    echo "Please enable sysctl support."; \
	    exit 1; \
	fi
	
ifeq ($(strip $(BUS)),PCI)
	@# check PCI support
	@if [ -z "$(CONFIG_PCI)" ]; then \
	    echo "FAILED"; \
	    echo "Please enable PCI support."; \
	    exit 1; \
	fi
endif
	
	@# check wireless extensions support is enabled
	@if [ -z "$(CONFIG_NET_RADIO)$(CONFIG_WIRELESS_EXT)" ]; then \
	    echo "FAILED"; \
	    echo "Please enable wireless extensions."; \
	    exit 1; \
	fi
	
	@# check crypto support is enabled
	@if [ -z "$(CONFIG_CRYPTO)" ]; then \
	    echo "FAILED"; \
	    echo "Please enable crypto API."; \
	    exit 1; \
	fi
	
	@echo "ok."