📄 quick.start
字号:
The prefered method of installing a MPLS enabled kernel is to use theRPMs I have prepared. If you run a non RPM system you will haveto compile a kernel by hand. Here are some quick steps to help youget going:-get Linux kernel 2.6.15-change directory to /usr/src cd /usr/src-uncompress/untar linux-2.6.15.tar.gz tar -zxvf linux-2.6.15.tar.gz-uncompress/untar mpls-linux-1.950.tgz tar -zxvf mpls-linux-1.950.tgz-change directory to linux cd linux-2.6.15-patch Linux kernel for MPLS for Linux patch -p1 < ../mpls-linux/patches/linux-kernel.diff-configure Linux kernel to turn on MPLS (atleast the following) make menuconfigStandard config: Code maturity level options ---> [*] Prompt for development and/or incomplete code/drivers Networking options ---> [*] Multi Protocol Label Switching - MPLSFor more advanced traffic mappings (in addition to Standard config): [*] Network packet filtering (replaces ipchains) IP: Netfilter Configuration ---> <*> IP tables support (required for filtering/masq/NAT) <*> MPLS target support-compile and install kernel make clean ; make vmlinux (then follow the rules for your distrubution to install the kernel)-reboot-build the a MPLS enhanced version of iproute2 to create MPLS segments and bind routes to LSPs. (read patches/README.iproute2)-For more advanced traffic mappings you will need to use iptables (read patches/README.iptables)Additional Hints----------------1) Make sure you know what your old kernel config was before trying to configure a new kernel!!!!2) Make sure to do a 'make modules ; make modules_install' if you have configured any modules (you would have known that if you read linux/README).3) Don't send messages to the mailing list saying: "I installed the mpls-linux patch and now I can't run Xwindows or my network doesn't work" These are kernel config issues, (ie not related to mpls-linux) Go back and read linux/READMEGood luck!
⌨️ 快捷键说明
复制代码
Ctrl + C
搜索代码
Ctrl + F
全屏模式
F11
切换主题
Ctrl + Shift + D
显示快捷键
?
增大字号
Ctrl + =
减小字号
Ctrl + -