zl5011xadmmap.h

Zalink50114----TDMoIP芯片驱动源码

/*******************************************************************************
*
*  File name:              zl5011xAdmMap.h
*
*  Version:                17
*
*  Author:                 LCW
*
*  Date created:           27/3/2002
*
*  Copyright 2002, 2003, 2004, 2005, Zarlink Semiconductor Limited.
*  All rights reserved.
*
*  Module Description:
*   This is the map header file for the ADM block.
*
*  Revision History:
*
*  Rev:  Date:       Author:  Comments:
*  1     27/03/2002  LCW      Created.
*  2     28/03/2002  LCW      Minor mods.
*  3     03/04/2002  LCW      Minor mods.
*  4     03/04/2002  LCW      Minor mods.
*  5     16/04/2002  MRC      Minor mods.
*  6     27/03/2002  LCW      Minor mods.
*  7     17/04/2002  LCW      Code review actions.
*  8     18/04/2002  LCW      Code review actions.
*  9     18/04/2002  LCW      Changed interrupt & enable constants and
*                             registers.
*  10    23/04/2002  LCW      Code review actions.
*  11    26/04/2002  LCW      Minor mods.
*  12    18/04/2002  LCW      Code review actions.
*  13    02/10/2002  PJE      unwanted define
*  14    30/10/2002  MRC      Defined bit positions for the device ID register
*  15    31/10/2002  MRC      Added variants + minor fixes
*  16    14/02/2005  MRC      Updated compiler directive
*  17    11/04/2005  APL      Added initialisation interrupt definitions
*
*******************************************************************************/

#ifndef _ZL5011X_ADM_MAP_H_
#define _ZL5011X_ADM_MAP_H_

#ifdef __cplusplus
extern "C" {
#endif

/*****************   INCLUDE FILES   ******************************************/

/*****************   # DEFINES   **********************************************/
/* Register address offsets */
#define ZL5011X_ADM_MOD_RESET             ZL5011X_ADM_BASE + 0x00
#define ZL5011X_ADM_MOD_FREEZE            ZL5011X_ADM_BASE + 0x04
#define ZL5011X_ADM_MOD_MONITOR           ZL5011X_ADM_BASE + 0x08
#define ZL5011X_ADM_MOD_INIT_START        ZL5011X_ADM_BASE + 0x0C
#define ZL5011X_ADM_MOD_RUN               ZL5011X_ADM_BASE + 0x10
#define ZL5011X_ADM_MOD_GPIO_EN           ZL5011X_ADM_BASE + 0x14
#define ZL5011X_ADM_MOD_OP_REG            ZL5011X_ADM_BASE + 0x18
#define ZL5011X_ADM_MOD_GPIO_IN           ZL5011X_ADM_BASE + 0x1C
#define ZL5011X_ADM_MOD_IE0               ZL5011X_ADM_BASE + 0x20
#define ZL5011X_ADM_MOD_IE1               ZL5011X_ADM_BASE + 0x24
#define ZL5011X_ADM_MOD_IE2               ZL5011X_ADM_BASE + 0x28
#define ZL5011X_ADM_MOD_ICR               ZL5011X_ADM_BASE + 0x2C
#define ZL5011X_ADM_MOD_ISTAT             ZL5011X_ADM_BASE + 0x30
#define ZL5011X_ADM_MOD_IFR               ZL5011X_ADM_BASE + 0x34
#define ZL5011X_ADM_MOD_CHIP_ID           ZL5011X_ADM_BASE + 0x38
#define ZL5011X_ADM_MOD_INIT_TIMEOUT_REG  ZL5011X_ADM_BASE + 0x3C
#define ZL5011X_ADM_MOD_CONSTAT           ZL5011X_ADM_BASE + 0x40
#define ZL5011X_ADM_MOD_CONFIG            ZL5011X_ADM_BASE + 0x48

/* bit positions for ZL5011X_ADM_MOD_FREEZE register */
#define ZL5011X_ADM_SET_FREEZE_BIT          0
#define ZL5011X_ADM_FREEZE_STATUS_BIT       1
#define ZL5011X_ADM_GPIO_MASK               0x0000FFFF

/* bit positions for ZL5011X_ADM_MOD_CHIP_ID register */
#define ZL5011X_ADM_CHIP_ID_BITS            1
#define ZL5011X_ADM_CHIP_ID_MASK            (Uint32T)0x7ffffff

#define ZL5011X_ADM_CHIP_VERSION_BITS       28
#define ZL5011X_ADM_CHIP_VERSION_MASK       (Uint32T)0xf

#define ZL5011X_ADM_WAN_TX_ERROR_OVERFLOW_INTERRUPT 0
#define ZL5011X_ADM_WAN_TX_ERROR_QUEUE_INTERRUPT     1
#define ZL5011X_ADM_WAN_TX_INFO_OVERFLOW_INTERRUPT    2
#define ZL5011X_ADM_WAN_TX_INFO_QUEUE_INTERRUPT 3
#define ZL5011X_ADM_WAN_TX_QUEUE_INTERRUPT 4
#define ZL5011X_ADM_WAN_TX_OVERFLOW_INTERRUPT 5
#define ZL5011X_ADM_WAN_TX_GRANULES_INTERRUPT 6
#define ZL5011X_ADM_WAN_RX_QUEUE_INTERRUPT 7
#define ZL5011X_ADM_WAN_RX_OVERFLOW_INTERRUPT 8
#define ZL5011X_ADM_WAN_RX_TASK_OVERFLOW_INTERRUPT 9
#define ZL5011X_ADM_RTP_STATS_INTERRUPT 10
#define ZL5011X_ADM_CLOCK_INTERRUPT 11
#define ZL5011X_ADM_MEMORY_PARITY_INTERRUPT 12
#define ZL5011X_ADM_MAC_IF_INTERRUPT 13
#define ZL5011X_ADM_PACKET_TX_INTERRUPT 14
#define ZL5011X_ADM_PACKET_RX_INTERRUPT 15
#define ZL5011X_ADM_TASK_CONTROL_INTERRUPT 16
#define ZL5011X_ADM_GRANULE_INTERRUPT 17
#define ZL5011X_ADM_HOST_OVERFLOW_INTERRUPT 18
#define ZL5011X_ADM_HOST_QUEUE_INTERRUPT 19
#define ZL5011X_ADM_HOST_GRANULES_INTERRUPT 20
#define ZL5011X_ADM_DMA_RX_INTERRUPT 21
#define ZL5011X_ADM_DMA_TX_INTERRUPT 22

/* The following interrupts are for internal use only */
#define ZL5011X_ADM_INIT_DONE_INTERRUPT 30
#define ZL5011X_ADM_INIT_ERROR_INTERRUPT 31

/*****************   DATA TYPES   *********************************************/


/*****************   DATA STRUCTURES   ****************************************/


/*****************   EXPORTED GLOBAL VARIABLE DECLARATIONS   ******************/


/*****************   EXTERNAL FUNCTION DECLARATIONS   *************************/


#ifdef __cplusplus
}
#endif

#endif /* _ZL5011X_ADM_MAP_H_ */