net.cfg

鼎铭在线al-100tx网卡驱动程序（xp不自驱

; **************************************************************************
;  NET.CFG for SVA IS591 10/100 Base-Tx Fast Ethernet Adapter                   
; **************************************************************************
;
Link Driver RTSODI

; When using two or more adapters in a single machine, it is necessary to
; specifiy which adapter should be used. The following two parameters are
; used for this purpose:
;
;  BUSNO NN,   where NN is the PCI bus identifier of the PCI bus which connects
;              to the adapter.
;  DEVICENO NN, where NN is the specific PCI BIOS device identification number
;               of the specified PCI adapter.
;
;       BUSNO 0
;       DEVICENO 9
;
;  or you can use ETHERID to designate adapter by its Node Address
;
;       ETHERID <adapter's node address>
;
;       ETHERID 52544c812901
;
; Remove the semi-colon in front of the frame type you will use.
; This frame type must match what the NetWare server is using.
   FRAME Ethernet_802.2
   FRAME Ethernet_802.3
   FRAME Ethernet_SNAP
   FRAME Ethernet_II
;
;
; This is the driver default
;
;      FRAME ETHERNET_802.2
;
; Specify adapter's medium which identifys adapter's speed and duplex mode.
; There are  five medium values: AUTO, 10HALF, 10FULL, 100HALF, 100FULL.
; For Example:
;
       MEDIUM  AUTO     ;operate on auto negotiation mode
;       MEDIUM  10HALF   ;operate on 10M/HalfDuplex mode
;       MEDIUM  10FULL   ;operate on 10M/Fullduplex mode
;       MEDIUM  100HALF  ;operate on 100M/HalfDuplex mode
;       MEDIUM  100FULL  ;operate on 100M/Fullduplex mode
;

NetWare DOS Requester
        FIRST NETWORK DRIVE = F
        NETWARE PROTOCOL = NDS BIND
        MAX IPG = 0
; If you know the name of your preferred server, remove the
; semi-colon below and enter the preferred server name after
; the equal sign.
;preferred server =

;
; %VER NET.CFG - sample Netware DOS ODI configuration file V4.1d