system.mhs

Spartan3_virtualplatform_8_1

# ##############################################################################
# Created by Base System Builder Wizard for Xilinx EDK 7.1 Build EDK_H.10.2
# Sun Jan 30 20:49:17 2005
# Target Board:  Xilinx Spartan-3 Starter Board Rev E
# Family:	 spartan3
# Device:	 XC3S200
# Package:	 FT256
# Speed Grade:	 -4
# Processor: Microblaze
# System clock frequency: 50.000000 MHz
# Debug interface: On-Chip HW Debug Module
# Instruction Cache: 1024 KB
# On Chip Memory :   16 KB
# Total Off Chip Memory :   1 MB
# - SRAM_256Kx32 =   1 MB
# ##############################################################################


 PARAMETER VERSION = 2.1.0


 PORT fpga_0_RS232_RX_pin = fpga_0_RS232_RX, DIR = INPUT
 PORT fpga_0_RS232_TX_pin = fpga_0_RS232_TX, DIR = OUTPUT
 PORT fpga_0_LEDs_8Bit_GPIO_d_out_pin = fpga_0_LEDs_8Bit_GPIO_d_out, DIR = OUTPUT, VEC = [0:7]
 PORT fpga_0_SRAM_256Kx32_Mem_A_pin = fpga_0_SRAM_256Kx32_Mem_A, DIR = OUTPUT, VEC = [12:29]
 PORT fpga_0_SRAM_256Kx32_Mem_DQ_pin = fpga_0_SRAM_256Kx32_Mem_DQ, DIR = INOUT, VEC = [0:31]
 PORT fpga_0_SRAM_256Kx32_Mem_OEN_pin = fpga_0_SRAM_256Kx32_Mem_OEN, DIR = OUTPUT, VEC = [0:0]
 PORT fpga_0_SRAM_256Kx32_Mem_CEN_pin = fpga_0_SRAM_256Kx32_Mem_CEN, DIR = OUTPUT, VEC = [0:0]
 PORT fpga_0_SRAM_256Kx32_Mem_CEN_1_pin = fpga_0_SRAM_256Kx32_Mem_CEN, DIR = OUTPUT, VEC = [0:0]
 PORT fpga_0_SRAM_256Kx32_Mem_WEN_pin = fpga_0_SRAM_256Kx32_Mem_WEN, DIR = OUTPUT
 PORT fpga_0_SRAM_256Kx32_Mem_BEN_pin = fpga_0_SRAM_256Kx32_Mem_BEN, DIR = OUTPUT, VEC = [0:3]
 PORT sys_clk_pin = sys_clk_s, DIR = INPUT, SIGIS = CLK
 PORT sys_rst_pin = sys_rst_s, DIR = INPUT


BEGIN microblaze
 PARAMETER INSTANCE = microblaze_0
 PARAMETER HW_VER = 4.00.a
 PARAMETER C_DEBUG_ENABLED = 1
 PARAMETER C_NUMBER_OF_PC_BRK = 2
 PARAMETER C_NUMBER_OF_RD_ADDR_BRK = 1
 PARAMETER C_NUMBER_OF_WR_ADDR_BRK = 1
 PARAMETER C_USE_BARREL = 1
 PARAMETER C_USE_DIV = 1
 PARAMETER C_USE_ICACHE = 1
 PARAMETER C_CACHE_BYTE_SIZE = 8192
 PARAMETER C_USE_DCACHE = 0
 PARAMETER C_ICACHE_BASEADDR = 0x20100000
 PARAMETER C_ICACHE_HIGHADDR = 0x201fffff
 PARAMETER C_ADDR_TAG_BITS = 7
 PARAMETER C_USE_FPU = 0
 BUS_INTERFACE DOPB = mb_opb
 BUS_INTERFACE IOPB = mb_opb
 BUS_INTERFACE DLMB = dlmb
 BUS_INTERFACE ILMB = ilmb
 PORT CLK = sys_clk_s
 PORT DBG_CAPTURE = DBG_CAPTURE_s
 PORT DBG_CLK = DBG_CLK_s
 PORT DBG_REG_EN = DBG_REG_EN_s
 PORT DBG_TDI = DBG_TDI_s
 PORT DBG_TDO = DBG_TDO_s
 PORT DBG_UPDATE = DBG_UPDATE_s
 PORT Interrupt = Interrupt
END

BEGIN opb_v20
 PARAMETER INSTANCE = mb_opb
 PARAMETER HW_VER = 1.10.c
 PARAMETER C_EXT_RESET_HIGH = 1
 PORT SYS_Rst = sys_rst_s
 PORT OPB_Clk = sys_clk_s
END

BEGIN opb_mdm
 PARAMETER INSTANCE = debug_module
 PARAMETER HW_VER = 2.00.a
 PARAMETER C_MB_DBG_PORTS = 1
 PARAMETER C_USE_UART = 1
 PARAMETER C_UART_WIDTH = 8
 PARAMETER C_BASEADDR = 0x41400000
 PARAMETER C_HIGHADDR = 0x4140ffff
 BUS_INTERFACE SOPB = mb_opb
 PORT OPB_Clk = sys_clk_s
 PORT DBG_CAPTURE_0 = DBG_CAPTURE_s
 PORT DBG_CLK_0 = DBG_CLK_s
 PORT DBG_REG_EN_0 = DBG_REG_EN_s
 PORT DBG_TDI_0 = DBG_TDI_s
 PORT DBG_TDO_0 = DBG_TDO_s
 PORT DBG_UPDATE_0 = DBG_UPDATE_s
END

BEGIN lmb_v10
 PARAMETER INSTANCE = ilmb
 PARAMETER HW_VER = 1.00.a
 PARAMETER C_EXT_RESET_HIGH = 1
 PORT SYS_Rst = sys_rst_s
 PORT LMB_Clk = sys_clk_s
END

BEGIN lmb_v10
 PARAMETER INSTANCE = dlmb
 PARAMETER HW_VER = 1.00.a
 PARAMETER C_EXT_RESET_HIGH = 1
 PORT SYS_Rst = sys_rst_s
 PORT LMB_Clk = sys_clk_s
END

BEGIN lmb_bram_if_cntlr
 PARAMETER INSTANCE = dlmb_cntlr
 PARAMETER HW_VER = 1.00.b
 PARAMETER C_BASEADDR = 0x00000000
 PARAMETER C_HIGHADDR = 0x00001fff
 BUS_INTERFACE SLMB = dlmb
 BUS_INTERFACE BRAM_PORT = dlmb_port
END

BEGIN lmb_bram_if_cntlr
 PARAMETER INSTANCE = ilmb_cntlr
 PARAMETER HW_VER = 1.00.b
 PARAMETER C_BASEADDR = 0x00000000
 PARAMETER C_HIGHADDR = 0x00001fff
 BUS_INTERFACE SLMB = ilmb
 BUS_INTERFACE BRAM_PORT = ilmb_port
END

BEGIN bram_block
 PARAMETER INSTANCE = lmb_bram
 PARAMETER HW_VER = 1.00.a
 BUS_INTERFACE PORTA = ilmb_port
 BUS_INTERFACE PORTB = dlmb_port
END

BEGIN opb_uartlite
 PARAMETER INSTANCE = RS232
 PARAMETER HW_VER = 1.00.b
 PARAMETER C_BAUDRATE = 19200
 PARAMETER C_DATA_BITS = 8
 PARAMETER C_ODD_PARITY = 0
 PARAMETER C_USE_PARITY = 0
 PARAMETER C_CLK_FREQ = 50000000
 PARAMETER C_BASEADDR = 0x40600000
 PARAMETER C_HIGHADDR = 0x4060ffff
 BUS_INTERFACE SOPB = mb_opb
 PORT OPB_Clk = sys_clk_s
 PORT RX = fpga_0_RS232_RX
 PORT TX = fpga_0_RS232_TX
END

BEGIN opb_gpio
 PARAMETER INSTANCE = LEDs_8Bit
 PARAMETER HW_VER = 3.01.b
 PARAMETER C_GPIO_WIDTH = 8
 PARAMETER C_IS_DUAL = 0
 PARAMETER C_IS_BIDIR = 0
 PARAMETER C_ALL_INPUTS = 0
 PARAMETER C_BASEADDR = 0x40000000
 PARAMETER C_HIGHADDR = 0x4000ffff
 BUS_INTERFACE SOPB = mb_opb
 PORT OPB_Clk = sys_clk_s
 PORT GPIO_d_out = fpga_0_LEDs_8Bit_GPIO_d_out
END

BEGIN opb_emc
 PARAMETER INSTANCE = SRAM_256Kx32
 PARAMETER HW_VER = 2.00.a
 PARAMETER C_OPB_CLK_PERIOD_PS = 20000
 PARAMETER C_NUM_BANKS_MEM = 1
 PARAMETER C_TCEDV_PS_MEM_0 = 10000
 PARAMETER C_TWC_PS_MEM_0 = 8000
 PARAMETER C_TAVDV_PS_MEM_0 = 10000
 PARAMETER C_TWP_PS_MEM_0 = 8000
 PARAMETER C_MEM0_BASEADDR = 0x20100000
 PARAMETER C_MEM0_HIGHADDR = 0x201fffff
 BUS_INTERFACE SOPB = mb_opb
 PORT OPB_Clk = sys_clk_s
 PORT Mem_A = fpga_0_SRAM_256Kx32_Mem_A_split
 PORT Mem_DQ = fpga_0_SRAM_256Kx32_Mem_DQ
 PORT Mem_OEN = fpga_0_SRAM_256Kx32_Mem_OEN
 PORT Mem_CEN = fpga_0_SRAM_256Kx32_Mem_CEN
 PORT Mem_WEN = fpga_0_SRAM_256Kx32_Mem_WEN
 PORT Mem_BEN = fpga_0_SRAM_256Kx32_Mem_BEN
END

BEGIN opb_timer
 PARAMETER INSTANCE = opb_timer_1
 PARAMETER HW_VER = 1.00.b
 PARAMETER C_COUNT_WIDTH = 32
 PARAMETER C_ONE_TIMER_ONLY = 1
 PARAMETER C_BASEADDR = 0x41c00000
 PARAMETER C_HIGHADDR = 0x41c0ffff
 BUS_INTERFACE SOPB = mb_opb
 PORT OPB_Clk = sys_clk_s
 PORT Interrupt = opb_timer_1_Interrupt
END

BEGIN opb_intc
 PARAMETER INSTANCE = opb_intc_0
 PARAMETER HW_VER = 1.00.c
 PARAMETER C_BASEADDR = 0x41200000
 PARAMETER C_HIGHADDR = 0x4120ffff
 BUS_INTERFACE SOPB = mb_opb
 PORT Irq = Interrupt
 PORT Intr = opb_timer_1_Interrupt
END

BEGIN util_bus_split
 PARAMETER INSTANCE = SRAM_256Kx32_util_bus_split_0
 PARAMETER HW_VER = 1.00.a
 PARAMETER C_SIZE_IN = 32
 PARAMETER C_LEFT_POS = 12
 PARAMETER C_SPLIT = 30
 PORT Sig = fpga_0_SRAM_256Kx32_Mem_A_split
 PORT Out1 = fpga_0_SRAM_256Kx32_Mem_A
END