config.in

来自「linux嵌入式课程实践中的一个关于声卡驱动程序 。」· IN 代码 · 共 31 行

# drivers/mtd/nand/Config.in

# $Id: Config.in,v 1.8 2002/04/30 09:34:16 mag Exp $

mainmenu_option next_comment

comment 'NAND Flash Device Drivers'

dep_tristate '  NAND Device Support' CONFIG_MTD_NAND $CONFIG_MTD
if [ "$CONFIG_MTD_NAND" = "y" -o "$CONFIG_MTD_NAND" = "m" ]; then
   bool '    Enable ECC correction algorithm'  CONFIG_MTD_NAND_ECC
   bool '    Verify NAND page writes' CONFIG_MTD_NAND_VERIFY_WRITE
   if [ "$CONFIG_JFFS2_FS" = "y" -o "$CONFIG_JFFS2_FS" = "m" ]; then
   	bool '    Use JFFS2 layout for OOB area' CONFIG_MTD_NAND_ECC_JFFS2
   fi
fi

if [ "$CONFIG_ARM" = "y" -a "$CONFIG_ARCH_P720T" = "y" ]; then
   dep_tristate '  NAND Flash device on SPIA board' CONFIG_MTD_NAND_SPIA $CONFIG_MTD_NAND
fi

if [ "$CONFIG_ARCH_AUTCPU12" = "y" ]; then
   dep_tristate ' SmartMedia Card on AUTCPU12 board' CONFIG_MTD_NAND_AUTCPU12 $CONFIG_MTD_NAND
fi

if [ "$CONFIG_ARCH_EDB7312" = "y" ]; then
   dep_tristate '  NAND Flash device on EDP7312 board' CONFIG_MTD_NAND_EDB7312 $CONFIG_MTD_NAND
fi

endmenu