📄 msp430i2cc.nc
字号:
// $Id: MSP430I2CC.nc,v 1.1 2005/01/24 02:33:04 jpolastre Exp $/* * "Copyright (c) 2000-2005 The Regents of the University of California. * All rights reserved. * * Permission to use, copy, modify, and distribute this software and its * documentation for any purpose, without fee, and without written agreement is * hereby granted, provided that the above copyright notice, the following * two paragraphs and the author appear in all copies of this software. * * IN NO EVENT SHALL THE UNIVERSITY OF CALIFORNIA BE LIABLE TO ANY PARTY FOR * DIRECT, INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES ARISING OUT * OF THE USE OF THIS SOFTWARE AND ITS DOCUMENTATION, EVEN IF THE UNIVERSITY OF * CALIFORNIA HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. * * THE UNIVERSITY OF CALIFORNIA SPECIFICALLY DISCLAIMS ANY WARRANTIES, * INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY * AND FITNESS FOR A PARTICULAR PURPOSE. THE SOFTWARE PROVIDED HEREUNDER IS * ON AN "AS IS" BASIS, AND THE UNIVERSITY OF CALIFORNIA HAS NO OBLIGATION TO * PROVIDE MAINTENANCE, SUPPORT, UPDATES, ENHANCEMENTS, OR MODIFICATIONS." *//** * @author Joe Polastre * Revision: $Revision: 1.1 $ * * Primitives for accessing the hardware I2C module on MSP430 microcontrollers. * This configuration assumes that the bus is available and reserved * prior to use; aka Bus Arbitration occurs before start() is called. * Once the bus is acquired, call start() and then the commands in this module * may be used. Likewise, stop() should be called before releasing the bus. */configuration MSP430I2CC{ provides { interface StdControl; interface MSP430I2C; interface MSP430I2CPacket; interface MSP430I2CEvents; }}implementation{ components HPLUSART0M, MSP430I2CM as I2CM; StdControl = I2CM; MSP430I2C = I2CM; MSP430I2CPacket = I2CM; MSP430I2CEvents = I2CM; I2CM.USARTControl -> HPLUSART0M; I2CM.HPLI2CInterrupt -> HPLUSART0M;}
⌨️ 快捷键说明
复制代码
Ctrl + C
搜索代码
Ctrl + F
全屏模式
F11
切换主题
Ctrl + Shift + D
显示快捷键
?
增大字号
Ctrl + =
减小字号
Ctrl + -