config.h

是一个非常实用的基于９０５的无线模块的驱动程序

#ifdef __SRC
	#define EXTERN
#else
	#define EXTERN	extern
#endif

#include "Reg932.h"
#include "INTRINS.H"

#define uchar 	unsigned char
#define uint	unsigned int
#define ulong	unsigned long

/*-----------------------------------------------
        nrf905命令控制字
------------------------------------------------*/
#define WC        0x00            // Write configuration register command
#define RC        0x10             // Read  configuration register command
#define WTP        0x20             // Write TX Payload  command
#define RTP        0x21            // Read  TX Payload  command
#define WTA        0x22            // Write TX Address  command
#define RTA        0x23            // Read  TX Address  command
#define RRP        0x24            // Read  RX Payload  command
/*-----------------------------------------------
        nrf905模式定义
------------------------------------------------*/
#define PowerDown	1
#define Standby		2
#define RDMode		3
#define RXMode		4
#define TXMode 		5
#define TXData		6
/*------------------------------------------------
	I/O Port Define
---------------------------------------------------*/
sbit LED0 = P0^0;
sbit LED1 = P0^1;
sbit LED2 = P0^2;
sbit LED3 = P0^3;
sbit Key1 = P0^6;
sbit Key2 = P0^7;
sbit Key3 = P0^5;
sbit Key4 = P0^4;

sbit RFCSN = P2^4;
sbit RFSCK = P2^5;
sbit RFMOSI = P2^2;
sbit RFMISO = P2^3;
sbit TX_EN = P1^3;
sbit TRX_EN = P1^2;
sbit RFPWR = P1^4;
sbit RF_AM = P2^0;
sbit RF_DR = P2^6;

#undef EXTERN