📄 f34x_msd_sect_serv.lst
字号:
98 =2 // HID Descriptor Types
99 =2 #define DSC_HID 0x21 // HID Class Descriptor
100 =2 #define DSC_HID_REPORT 0x22 // HID Report Descriptor
101 =2
102 =2 // Standard Request Codes
103 =2 #define GET_STATUS 0x00 // Code for Get Status
104 =2 #define CLEAR_FEATURE 0x01 // Code for Clear Feat
-ure
105 =2 #define SET_FEATURE 0x03 // Code for Set Featur
-e
106 =2 #define SET_ADDRESS 0x05 // Code for Set Addres
-s
107 =2 #define GET_DESCRIPTOR 0x06 // Code for Get Descri
-ptor
108 =2 #define SET_DESCRIPTOR 0x07 // Code for Set Descri
-ptor(not used)
109 =2 #define GET_CONFIGURATION 0x08 // Code for Get Config
-uration
110 =2 #define SET_CONFIGURATION 0x09 // Code for Set Config
-uration
111 =2 #define GET_INTERFACE 0x0A // Code for Get Interf
-ace
112 =2 #define SET_INTERFACE 0x0B // Code for Set Interf
-ace
113 =2 #define SYNCH_FRAME 0x0C // Code for Synch Fram
-e(not used)
114 =2 #define MSD_RESET 0xFF // Mass-storage device Reset
115 =2 #define MSD_GET_MAX_LUN 0xFE // Mass-storage device Get Max LU
-N
116 =2
117 =2 // HID Request Codes
118 =2 #define GET_REPORT 0x01 // Code for Get Report
119 =2 #define GET_IDLE 0x02 // Code for Get Idle
120 =2 #define GET_PROTOCOL 0x03 // Code for Get Protocol
121 =2 #define SET_REPORT 0x09 // Code for Set Report
122 =2 #define SET_IDLE 0x0A // Code for Set Idle
123 =2 #define SET_PROTOCOL 0x0B // Code for Set Protocol
124 =2
125 =2 // Define device states
126 =2 #define DEV_ATTACHED 0x00 // Device is in Attac
-hed State
127 =2 #define DEV_POWERED 0x01 // Device is in Power
-ed State
128 =2 #define DEV_DEFAULT 0x02 // Device is in Defau
-lt State
129 =2 #define DEV_ADDRESS 0x03 // Device is in Addre
-ssed State
130 =2 #define DEV_CONFIGURED 0x04 // Device is in Confi
-gured State
131 =2 #define DEV_SUSPENDED 0x05 // Device is in Suspe
-nded State
132 =2
133 =2 // Define bmRequestType bitmaps
134 =2 #define IN_DEVICE 0x00 // Request made to de
-vice, direction is IN
135 =2 #define OUT_DEVICE 0x80 // Request made to de
-vice, direction is OUT
136 =2 #define IN_INTERFACE 0x01 // Request made to in
-terface, direction is IN
137 =2 #define OUT_INTERFACE 0x81 // Request made to in
-terface, direction is OUT
C51 COMPILER V7.50 F34X_MSD_SECT_SERV 11/28/2006 10:54:26 PAGE 14
138 =2 #define IN_ENDPOINT 0x02 // Request made to en
-dpoint, direction is IN
139 =2 #define OUT_ENDPOINT 0x82 // Request made to en
-dpoint, direction is OUT
140 =2
141 =2 // Define wIndex bitmaps
142 =2 #define IN_EP1 0x81 // Index values used
-by Set and Clear feature
143 =2 #define OUT_EP1 0x01 // commands for Endpo
-int_Halt
144 =2 #define IN_EP2 0x82
145 =2 #ifdef __F326_VER__
=2 #define OUT_EP2 0x01
=2 #else
148 =2 #define OUT_EP2 0x01
149 =2 #endif
150 =2
151 =2 // Define wValue bitmaps for Standard Feature Selectors
152 =2 #define DEVICE_REMOTE_WAKEUP 0x01 // Remote wakeup feat
-ure(not used)
153 =2 #define ENDPOINT_HALT 0x00 // Endpoint_Halt feat
-ure selector
154 =2
155 =2 // Define Endpoint States
156 =2 #define EP_IDLE 0x00 // This signifies End
-point Idle State
157 =2 #define EP_TX 0x01 // Endpoint Transmit
-State
158 =2 #define EP_RX 0x02 // Endpoint Receive S
-tate
159 =2 #define EP_HALT 0x03 // Endpoint Halt Stat
-e (return stalls)
160 =2 #define EP_STALL 0x04 // Endpoint Stall (se
-nd procedural stall next status phase)
161 =2 #define EP_ADDRESS 0x05 // Endpoint Address (
-change FADDR during next status phase)
162 =2
163 =2 // Function prototypes
164 =2 // USB Routines
165 =2 void USB_Resume(void); // This routine resum
-es USB operation
166 =2 void USB_Reset(void); // Called after USB b
-us reset
167 =2 void Handle_Setup(void); // Handle setup packe
-t on Endpoint 0
168 =2 void Handle_In1(BYTE* ptr_buf); // Handle in
- packet on Endpoint 1
169 =2 void Handle_Out2(void); // Handle out packet
-on Endpoint 2
170 =2 void USB_Suspend(void); // This routine calle
-d when suspend signalling on bus
171 =2 void Out2_Get_Data(BYTE* ptr_buf); // Copies from FIFO to ptr_
-buf, clears FIFO-full flag.
172 =2 void Out2_Done(void); // Call this when finished with the d
-ata
173 =2
174 =2 // Standard Requests
175 =2 void Get_Status(void); // These are called f
-or each specific standard request
176 =2 void Clear_Feature(void);
177 =2 void Set_Feature(void);
178 =2 void Set_Address(void);
C51 COMPILER V7.50 F34X_MSD_SECT_SERV 11/28/2006 10:54:26 PAGE 15
179 =2 void Get_Descriptor(void);
180 =2 void Get_Configuration(void);
181 =2 void Set_Configuration(void);
182 =2 void Get_Interface(void);
183 =2 void Set_Interface(void);
184 =2
185 =2 // MSD Specific Requests
186 =2 // void Reset_Msd(void);
187 =2 // void Get_MaxLUN(void);
188 =2
189 =2 // Initialization Routines
190 =2 void Sys_Clk_Init(void); // Initialize the sy
-stem clock(depends on Full/Low speed)
191 =2 void Port_Init(void); // Configure ports fo
-r this specific application
192 =2 void USB0_Init(void); // Configure USB core
- for either Full/Low speed
193 =2 void Timer_Init(void); // Start timer 2 for
-use by ADC and to check switches
194 =2 void Adc_Init(void); // Configure ADC for
-continuous conversion, low-power mode
195 =2
196 =2 // Other Routines
197 =2 void Timer2_ISR(void); // Called when Timer
-2 overflows, see if switches are pressed
198 =2 void Adc_ConvComple_ISR(void); // When a conversion
-completes, switch ADC multiplexor
199 =2 void USB_ISR(void); // Called to determin
-e type of USB interrupt
200 =2 void Fifo_ReadC(BYTE, unsigned int, BYTE *) ;
201 =2 extern void Fifo_Read (BYTE, unsigned int, BYTE *) ; // Used for m
-ultiple byte reads of Endpoint fifos
202 =2 extern void Fifo_Write (BYTE, unsigned int, BYTE *) reentrant;// U
-sed for multiple byte writes of Endpoint fifos
203 =2 void Force_Stall(void); // Forces a procedura
-l stall on Endpoint 0
204 =2 void Delay(void); // Approximately 80 u
-s/1 ms on Full/Low Speed
205 =2
206 =2 void USB_In(BYTE* ptr_buf,unsigned count);
207 =2
208 =2 void USB_Bulk_Init(void);
209 =2
210 =2 extern unsigned xdata Out_Count;
211 =2 extern BYTE xdata Out_Packet[EP2_PACKET_SIZE];
212 =2 extern BYTE xdata In_count;
213 =2 extern BYTE xdata In_Packet[EP1_PACKET_SIZE];
214 =2 //extern BYTE xdata In_Overrun;
215 =2
216 =2 #endif /* _USB_MAIN_H_ */
217 =2
35 =1 #include "F34x_MSD_Physical_Settings.h"
1 =2 //----------------------------------------------------------------
--------------
2 =2 // F34x_MSD_Physical_Settings.h
3 =2 //----------------------------------------------------------------
--------------
4 =2 // Copyright 2006 Silicon Laboratories, Inc.
5 =2 // http://www.silabs.com
6 =2 //
7 =2 // Program Description:
8 =2 //
C51 COMPILER V7.50 F34X_MSD_SECT_SERV 11/28/2006 10:54:26 PAGE 16
9 =2 // Header file with common definitions
10 =2 //
11 =2 //
12 =2 // FID: 34X000048
13 =2 // Target: C8051F34x
14 =2 // Tool chain: Keil
15 =2 // Command Line: See Readme.txt
16 =2 // Project Name: F34x_USB_MSD
17 =2 //
18 =2 // Release 1.1
19 =2 // -All changes by PKC
20 =2 // -09 JUN 2006
21 =2 // -Replaced SFR definitions file "c8051f320.h" with "c8051f340
-.h"
22 =2 //
23 =2 // Release 1.0
24 =2 // -Initial Release
25 =2 //
26 =2
27 =2 //----------------------------------------------------------------
--------------
28 =2 // Header File Preprocessor Directive
29 =2 //----------------------------------------------------------------
--------------
30 =2
31 =2 #ifndef __PHYSICAL_SETTINGS_H__
32 =2 #define __PHYSICAL_SETTINGS_H__
33 =2
34 =2 #include "c8051f340.h"
1 =3 //----------------------------------------------------------------
--------------
2 =3 // C8051F340.h
3 =3 //----------------------------------------------------------------
--------------
4 =3 // Copyright 2005 Silicon Laboratories, Inc.
5 =3 // http://www.silabs.com
6 =3 //
7 =3 // Program Description:
8 =3 //
9 =3 // Register/bit definitions for the C8051F34x family.
10 =3 //
11 =3 //
12 =3 // FID: 34X000002
13 =3 // Target: C8051F340, 'F341, 'F342, 'F343, 'F344, 'F345, '
-F346, 'F347
14 =3 // Tool chain: Keil
15 =3 // Command Line: None
16 =3 //
17 =3 // Release 1.0
18 =3 // -Initial Release (GP\PKC)
19 =3 // -13 DEC 2005
20 =3
21 =3 //----------------------------------------------------------------
--------------
22 =3 // Header File Preprocessor Directive
23 =3 //----------------------------------------------------------------
--------------
24 =3
25 =3 #ifndef C8051F340_H
=3 #define C8051F340_H
=3
=3 //----------------------------------------------------------------
C51 COMPILER V7.50 F34X_MSD_SECT_SERV 11/28/2006 10:54:26 PAGE 17
--------------
=3 // Byte Registers
⌨️ 快捷键说明
复制代码
Ctrl + C
搜索代码
Ctrl + F
全屏模式
F11
切换主题
Ctrl + Shift + D
显示快捷键
?
增大字号
Ctrl + =
减小字号
Ctrl + -