⭐ 欢迎来到虫虫下载站! | 📦 资源下载 📁 资源专辑 ℹ️ 关于我们
⭐ 虫虫下载站

📄 orinoco_tmd.c

📁 h内核
💻 C
字号:
/* orinoco_tmd.c *  * Driver for Prism II devices which would usually be driven by orinoco_cs, * but are connected to the PCI bus by a TMD7160.  * * Copyright (C) 2003 Joerg Dorchain <joerg AT dorchain.net> * based heavily upon orinoco_plx.c Copyright (C) 2001 Daniel Barlow * * The contents of this file are subject to the Mozilla Public License * Version 1.1 (the "License"); you may not use this file except in * compliance with the License. You may obtain a copy of the License * at http://www.mozilla.org/MPL/ * * Software distributed under the License is distributed on an "AS IS" * basis, WITHOUT WARRANTY OF ANY KIND, either express or implied. See * the License for the specific language governing rights and * limitations under the License. * * Alternatively, the contents of this file may be used under the * terms of the GNU General Public License version 2 (the "GPL"), in * which case the provisions of the GPL are applicable instead of the * above.  If you wish to allow the use of your version of this file * only under the terms of the GPL and not to allow others to use your * version of this file under the MPL, indicate your decision by * deleting the provisions above and replace them with the notice and * other provisions required by the GPL.  If you do not delete the * provisions above, a recipient may use your version of this file * under either the MPL or the GPL. * Caution: this is experimental and probably buggy.  For success and * failure reports for different cards and adaptors, see * orinoco_tmd_pci_id_table near the end of the file.  If you have a * card we don't have the PCI id for, and looks like it should work, * drop me mail with the id and "it works"/"it doesn't work". * * Note: if everything gets detected fine but it doesn't actually send * or receive packets, your first port of call should probably be to    * try newer firmware in the card.  Especially if you're doing Ad-Hoc * modes * * The actual driving is done by orinoco.c, this is just resource * allocation stuff. * * This driver is modeled after the orinoco_plx driver. The main * difference is that the TMD chip has only IO port ranges and no * memory space, i.e.  no access to the CIS. Compared to the PLX chip, * the io range functionalities are exchanged. * * Pheecom sells cards with the TMD chip as "ASIC version" */#define DRIVER_NAME "orinoco_tmd"#define PFX DRIVER_NAME ": "#include <linux/config.h>#include <linux/module.h>#include <linux/kernel.h>#include <linux/init.h>#include <linux/sched.h>#include <linux/ptrace.h>#include <linux/slab.h>#include <linux/string.h>#include <linux/timer.h>#include <linux/ioport.h>#include <asm/uaccess.h>#include <asm/io.h>#include <asm/system.h>#include <linux/netdevice.h>#include <linux/if_arp.h>#include <linux/etherdevice.h>#include <linux/list.h>#include <linux/pci.h>#include <linux/fcntl.h>#include <pcmcia/cisreg.h>#include "hermes.h"#include "orinoco.h"#define COR_VALUE	(COR_LEVEL_REQ | COR_FUNC_ENA) /* Enable PC card with interrupt in level trigger */static int orinoco_tmd_init_one(struct pci_dev *pdev,				const struct pci_device_id *ent){	int err = 0;	u32 reg, addr;	struct orinoco_private *priv = NULL;	unsigned long pccard_ioaddr = 0;	unsigned long pccard_iolen = 0;	struct net_device *dev = NULL;	err = pci_enable_device(pdev);	if (err)		return -EIO;	printk(KERN_DEBUG PFX "TMD setup\n");	pccard_ioaddr = pci_resource_start(pdev, 2);	pccard_iolen = pci_resource_len(pdev, 2);	if (! request_region(pccard_ioaddr, pccard_iolen, DRIVER_NAME)) {		printk(KERN_ERR PFX "I/O resource at 0x%lx len 0x%lx busy\n",			pccard_ioaddr, pccard_iolen);		pccard_ioaddr = 0;		err = -EBUSY;		goto fail;	}	addr = pci_resource_start(pdev, 1);	outb(COR_VALUE, addr);	mdelay(1);	reg = inb(addr);	if (reg != COR_VALUE) {		printk(KERN_ERR PFX "Error setting TMD COR values %x should be %x\n", reg, COR_VALUE);		err = -EIO;		goto fail;	}	/* Allocate network device */	dev = alloc_orinocodev(0, NULL);	if (! dev) {		err = -ENOMEM;		goto fail;	}	priv = netdev_priv(dev);	dev->base_addr = pccard_ioaddr;	SET_MODULE_OWNER(dev);	SET_NETDEV_DEV(dev, &pdev->dev);	printk(KERN_DEBUG PFX "Detected Orinoco/Prism2 TMD device "	       "at %s irq:%d, io addr:0x%lx\n", pci_name(pdev), pdev->irq,	       pccard_ioaddr);	hermes_struct_init(&(priv->hw), dev->base_addr,			HERMES_IO, HERMES_16BIT_REGSPACING);	pci_set_drvdata(pdev, dev);	err = request_irq(pdev->irq, orinoco_interrupt, SA_SHIRQ,			  dev->name, dev);	if (err) {		printk(KERN_ERR PFX "Error allocating IRQ %d.\n",		       pdev->irq);		err = -EBUSY;		goto fail;	}	dev->irq = pdev->irq;	err = register_netdev(dev);	if (err)		goto fail;	return 0; fail:	printk(KERN_DEBUG PFX "init_one(), FAIL!\n");	if (dev) {		if (dev->irq)			free_irq(dev->irq, dev);				free_netdev(dev);	}	if (pccard_ioaddr)		release_region(pccard_ioaddr, pccard_iolen);	pci_disable_device(pdev);	return err;}static void __devexit orinoco_tmd_remove_one(struct pci_dev *pdev){	struct net_device *dev = pci_get_drvdata(pdev);	BUG_ON(! dev);	unregister_netdev(dev);			if (dev->irq)		free_irq(dev->irq, dev);			pci_set_drvdata(pdev, NULL);	free_netdev(dev);	release_region(pci_resource_start(pdev, 2), pci_resource_len(pdev, 2));	pci_disable_device(pdev);}static struct pci_device_id orinoco_tmd_pci_id_table[] = {	{0x15e8, 0x0131, PCI_ANY_ID, PCI_ANY_ID,},      /* NDC and OEMs, e.g. pheecom */	{0,},};MODULE_DEVICE_TABLE(pci, orinoco_tmd_pci_id_table);static struct pci_driver orinoco_tmd_driver = {	.name		= DRIVER_NAME,	.id_table	= orinoco_tmd_pci_id_table,	.probe		= orinoco_tmd_init_one,	.remove		= __devexit_p(orinoco_tmd_remove_one),};static char version[] __initdata = DRIVER_NAME " " DRIVER_VERSION	" (Joerg Dorchain <joerg@dorchain.net>)";MODULE_AUTHOR("Joerg Dorchain <joerg@dorchain.net>");MODULE_DESCRIPTION("Driver for wireless LAN cards using the TMD7160 PCI bridge");MODULE_LICENSE("Dual MPL/GPL");static int __init orinoco_tmd_init(void){	printk(KERN_DEBUG "%s\n", version);	return pci_module_init(&orinoco_tmd_driver);}static void __exit orinoco_tmd_exit(void){	pci_unregister_driver(&orinoco_tmd_driver);	current->state = TASK_UNINTERRUPTIBLE;	schedule_timeout(HZ);}module_init(orinoco_tmd_init);module_exit(orinoco_tmd_exit);/* * Local variables: *  c-indent-level: 8 *  c-basic-offset: 8 *  tab-width: 8 * End: */

⌨️ 快捷键说明

复制代码 Ctrl + C
搜索代码 Ctrl + F
全屏模式 F11
切换主题 Ctrl + Shift + D
显示快捷键 ?
增大字号 Ctrl + =
减小字号 Ctrl + -