rfc1962.txt

改文件中包含了三个协议

Network Working Group                                            D. Rand
Request for Comments: 1962                                        Novell
Category: Standards Track                                      June 1996


               The PPP Compression Control Protocol (CCP)

Status of this Memo

   This document specifies an Internet standards track protocol for the
   Internet community, and requests discussion and suggestions for
   improvements.  Please refer to the current edition of the "Internet
   Official Protocol Standards" (STD 1) for the standardization state
   and status of this protocol.  Distribution of this memo is unlimited.

Abstract

   The Point-to-Point Protocol (PPP) [1] provides a standard method for
   transporting multi-protocol datagrams over point-to-point links.  PPP
   also defines an extensible Link Control Protocol.

   This document defines a method for negotiating data compression over
   PPP links.

Table of Contents

   1.     Introduction ..........................................    1
   2.     Compression Control Protocol (CCP) ....................    2
      2.1       Sending Compressed Datagrams ....................    3
   3.     Additional Packets ....................................    4
      3.1       Reset-Request and Reset-Ack .....................    4
   4.     CCP Configuration Options .............................    5
      4.1       Proprietary Compression OUI .....................    7
      4.2       Other Compression Types .........................    8
   SECURITY CONSIDERATIONS ......................................    9
   REFERENCES ...................................................    9
   ACKNOWLEDGEMENTS .............................................    9
   CHAIR'S ADDRESS ..............................................    9
   AUTHOR'S ADDRESS .............................................    9

1.  Introduction

   In order to establish communications over a PPP link, each end of the
   link must first send LCP packets to configure and test the data link
   during Link Establishment phase.  After the link has been
   established, optional facilities may be negotiated as needed.





Rand                        Standards Track                     [Page 1]

RFC 1962                    PPP Compression                    June 1996


   One such facility is data compression.  A wide variety of compression
   methods may be negotiated, although typically only one method is used
   in each direction of the link.

   A different compression algorithm may be negotiated in each
   direction, for speed, cost, memory or other considerations, or only
   one direction may be compressed.

2.  Compression Control Protocol (CCP)

   The Compression Control Protocol (CCP) is responsible for
   configuring, enabling, and disabling data compression algorithms on
   both ends of the point-to-point link.  It is also used to signal a
   failure of the compression/decompression mechanism in a reliable
   manner.

   CCP uses the same packet exchange mechanism as the Link Control
   Protocol (LCP).  CCP packets may not be exchanged until PPP has
   reached the Network-Layer Protocol phase.  CCP packets received
   before this phase is reached should be silently discarded.

   The Compression Control Protocol is exactly the same as the Link
   Control Protocol [1] with the following exceptions:

   Frame Modifications

      The packet may utilize any modifications to the basic frame format
      which have been negotiated during the Link Establishment phase.

   Data Link Layer Protocol Field

      Exactly one CCP packet is encapsulated in the PPP Information
      field, where the PPP Protocol field indicates type hex 80FD
      (Compression Control Protocol).

      When individual link data compression is used in a multiple link
      connection to a single destination, the PPP Protocol field
      indicates type hex 80FB (Individual link Compression Control
      Protocol).

   Code field

      In addition to Codes 1 through 7 (Configure-Request, Configure-
      Ack, Configure-Nak, Configure-Reject, Terminate-Request,
      Terminate-Ack and Code-Reject), two additional Codes 14 and 15
      (Reset-Request and Reset-Ack) are defined for this protocol.
      Other Codes should be treated as unrecognized and should result in
      Code-Rejects.



Rand                        Standards Track                     [Page 2]

RFC 1962                    PPP Compression                    June 1996


   Timeouts

      CCP packets may not be exchanged until PPP has reached the
      Network-Layer Protocol phase.  An implementation should be
      prepared to wait for Authentication and Link Quality Determination
      to finish before timing out waiting for a Configure-Ack or other
      response.  It is suggested that an implementation give up only
      after user intervention or a configurable amount of time.

   Configuration Option Types

      CCP has a distinct set of Configuration Options.

2.1.  Sending Compressed Datagrams

   Before any compressed packets may be communicated, PPP must reach the
   Network-Layer Protocol phase, and the Compression Control Protocol
   must reach the Opened state.

   One or more compressed packets are encapsulated in the PPP
   Information field, where the PPP Protocol field indicates type hex
   00FD (Compressed datagram).  Each of the compression algorithms may
   use a different mechanism to indicate the inclusion of more than one
   uncompressed packet in a single Data Link Layer frame.

   When using multiple PPP links to a single destination, there are two
   methods of employing data compression.  The first method is to
   compress the data prior to sending it out through the multiple links.
   The second is to treat each link as a separate connection, that may
   or may not have compression enabled.  In the second case, the PPP
   Protocol field MUST be type hex 00FB (Individual link compressed
   datagram).

   Only one primary algorithm in each direction is in use at a time, and
   that is negotiated prior to sending the first compressed frame.  The
   PPP Protocol field of the compressed datagram indicates that the
   frame is compressed, but not the algorithm with which it was
   compressed.

   The maximum length of a compressed packet transmitted over a PPP link
   is the same as the maximum length of the Information field of a PPP
   encapsulated packet.  Larger datagrams (presumably the result of the
   compression algorithm increasing the size of the message in some
   cases) may be sent uncompressed, using its standard form, or may be
   sent in multiple datagrams, if the compression algorithm supports it.

   Each of the compression algorithms must supply a way of determining
   if they are passing data reliably, or they must require the use of a



Rand                        Standards Track                     [Page 3]

RFC 1962                    PPP Compression                    June 1996


   reliable transport such as LAPB [3].  Vendors are strongly encouraged
   to employ a method of validating the compressed data, or recognizing
   out-of-sync compressor/decompressor pairs.

3.  Additional Packets

   The Packet format and basic facilities are already defined for LCP
   [1].

   Up-to-date values of the CCP Code field are specified in the most
   recent "Assigned Numbers" RFC [2].  This specification concerns the
   following values:

      14      Reset-Request
      15      Reset-Ack

3.1.  Reset-Request and Reset-Ack

   Description

      CCP includes Reset-Request and Reset-Ack Codes in order to provide
      a mechanism for indicating a decompression failure in one
      direction of a compressed link without affecting traffic in the
      other direction.  A decompression failure may be determined by
      periodically passing a hash value, performing a CRC check on the
      decompressed data, or other mechanism.  It is strongly suggested
      that some mechanism be available in all compression algorithms to
      validate the decompressed data before passing the data on to the
      rest of the system.

      A CCP implementation wishing to indicate a decompression failure
      SHOULD transmit a CCP packet with the Code field set to 14
      (Reset-Request), and the Data field filled with any desired data.
      Once a Reset-Request has been sent, any Compressed packets
      received are discarded, and another Reset-Request is sent with the
      same Identifier, until a valid Reset-Ack is received.

      Upon reception of a Reset-Request, the transmitting compressor is
      reset to an initial state.  This may include clearing a
      dictionary, resetting hash codes, or other mechanisms.  A CCP
      packet MUST be transmitted with the Code field set to 15 (Reset-
      Ack), the Identifier field copied from the Reset-Request packet,
      and the Data field filled with any desired data.

      On receipt of a Reset-Ack, the receiving decompressor is reset to
      an initial state.  This may include clearing a dictionary,
      resetting hash codes, or other mechanisms.  Since there may be
      several Reset-Acks in the pipe, the decompressor MUST be reset for



Rand                        Standards Track                     [Page 4]

RFC 1962                    PPP Compression                    June 1996


      each Reset-Ack which matches the currently expected identifier.

   A summary of the Reset-Request and Reset-Ack packet formats is shown
   below.  The fields are transmitted from left to right.

    0                   1                   2                   3
    0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
   +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
   |     Code      |  Identifier   |            Length             |
   +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
   |    Data ...
   +-+-+-+-+


   Code

      14 for Reset-Request;

      15 for Reset-Ack.

   Identifier

      On transmission, the Identifier field MUST be changed whenever the
      content of the Data field changes, and whenever a valid reply has