initall.h

此代码应用与f2812的通讯程序!!方便用户编程!

//全局定义
#ifndef INITALL_H
#define INITALL_H

//外部存储器件接口地址

//发光LED
#define LEDREG_ADD   0x4400

//键盘
#define KEYREG_ADD   0x2C00 

//继电器
#define YKREG_ADD    0x4200

//LCD控制寄存器
#define LCDCTRL_ADD  0x4000

//SSTFlash
#define EXFLASH_ADD	 0x80000

//SRAM
#define EXRAM_ADD    0x100000

//外部芯片选择

//SSTFLASH地址
#define SET_A19 GpioDataRegs.GPBDAT.bit.GPIOB6  
#define SET_A20 GpioDataRegs.GPBDAT.bit.GPIOB7 

//5323
#define cs5323Hig   GpioDataRegs.GPBDAT.bit.GPIOB0=1
#define cs5323Low   GpioDataRegs.GPBDAT.bit.GPIOB0=0

//1306
#define cs1306Hig   GpioDataRegs.GPBDAT.bit.GPIOB2=1
#define cs1306Low   GpioDataRegs.GPBDAT.bit.GPIOB2=0

//AD3578
#define CS3578H    	GpioDataRegs.GPEDAT.bit.GPIOE0 =1 
#define CS3578L  	GpioDataRegs.GPEDAT.bit.GPIOE0 =0

//通讯波特率
#define BD_300    0
#define BD_600    1
#define BD_1200   2
#define BD_2400   3
#define BD_4800   4
#define BD_9600   5
#define BD_19200  6
#define BD_38400  7
#define BD_57600  8
#define BD_115200 9 	
	
	


//函数声明

void InitAll(void);
void InitPara();
void DisInterWatchdog();
//void AdjustSample();

//void SelfTest(void);
void delay(unsigned int num);



//void DefaultParm();
void ReadParm();
void AdjParm();
//void AdjYcSet();
//void AdjComParm(void);
void GetSKPQ();


void ReadEEp5323(far int * Data,int Add,int Len);
void PreWritEEp(far int * Data,int Add,int Len);//prepare writting
void WriteEEp5323();
void ClearWatchDog();

void Init1306(void);
void SetTime1306();
void GetTime1306();
void Send1306byte(int Add,int data);
void Rev1306byte(int Add,int *RevData, int num);

Uint16 BCDtoHex(Uint16 bcd);
Uint16 HextoBCD(Uint16 hex);

#endif