readme.txt

Stellaris Luminary Micro 系列之 DK-LM3S102 多个学习范例全都是基于 Keil 工程版的范例, 而范例内容列举如下: 1.BitBand 2.Comparator

I2C

This example application uses the I2C master to communicate with the Atmel
AT24C08A EEPROM that is on the development board.  The first sixteen bytes of
the EEPROM are erased and then programmed with an incrementing sequence.  The
data is then read back to verify its correctness.  The transfer is managed by
an interrupt handler in response to the I2C interrupt; since a sixteen-byte
read at a 100kHz I2C bus speed takes almost 2ms, this allows a lot of other
processing to occur during the transfer (though that time is not utilized by
this example).

In order for this example to work properly, the I2C_SCL (JP14), I2C_SDA (JP13),
and I2CM_A2 (JP11) jumpers must be installed on the board, and the I2CM_WP
(JP12) jumper must be removed.

-------------------------------------------------------------------------------

Copyright (c) 2005,2006 Luminary Micro, Inc.  All rights reserved.

Software License Agreement

Luminary Micro, Inc. (LMI) is supplying this software for use solely and
exclusively on LMI's Stellaris Family of microcontroller products.

The software is owned by LMI and/or its suppliers, and is protected under
applicable copyright laws.  All rights are reserved.  Any use in violation of
the foregoing restrictions may subject the user to criminal sanctions under
applicable laws, as well as to civil liability for the breach of the terms and
conditions of this license.

THIS SOFTWARE IS PROVIDED "AS IS".  NO WARRANTIES, WHETHER EXPRESS, IMPLIED OR
STATUTORY, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY
AND FITNESS FOR A PARTICULAR PURPOSE APPLY TO THIS SOFTWARE.  LMI SHALL NOT, IN
ANY CIRCUMSTANCES, BE LIABLE FOR SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES,
FOR ANY REASON WHATSOEVER.

This is part of revision 852 of the Stellaris Driver Library.