readme.txt

富士通MB951F系列单片机的ADC采样控制DEMO程序

==========================================================================
                 ADC Project for 8FX Series (CONCERTO-Kit)
==========================================================================
                   Fujitsu Microelectronics Europe GmbH                       
                 http://emea.fujitsu.com/microelectronics 
                                                            
 The following  software  is for  demonstration  purposes only.  It is not
 fully  tested, nor validated  in order  to fullfill  its task  under  all
 circumstances.  Therefore,  this software or  any part of it must only be
 used in an evaluation laboratory environment.                        
 This software is subject to the rules of our standard DISCLAIMER, that is
 delivered with our  SW-tools on the Fujitsu Microcontrollers CD 
 (V3.4 or higher "\START.HTM") or on our Internet Pages:
 http://www.fme.gsdc.de/gsdc.htm
 http://emea.fujitsu.com/microelectronics 
==========================================================================
History
Date      Ver     Author  Softune     Description
27.12.04  1.0     MVo     V30L29      original version
04.07.05  1.1     MVo     V30L29      vectors.c updated
23.11.05  1.2     MVo     V30L29      set P30 as input (DDR3 = 0xfe)

==========================================================================

This is a project template for the MB95F108 (8FX Series)
that is used on the evaluation board CONCERT-Kit.

It includes some basic settings for e.g. Linker, C-Compiler 
which must be checked and modified in detail, 
corresponding to the user application.

Description:
The ADC Project initializes the ADC-Interface (Channel 0).
An interrupt is used to readout the Data. The activation is done via
software trigger, restarted in the ISR. Supply a voltage between 0 and 5 volts
to AN0 (pin 63 on CONCERTO-Kit). The voltage is output via UART to a terminal 
application (e.g. SKWizard) on your PC. The full voltage value is shown on the
7-segment display on CONCERTO-Kit.


NOTE: 
-----
This template uses the headerfiles mb95100.asm and mb95100.h 
of the 8FX evaluation chip MB95FV100 (HORN).
Take care that not all resources will be available 
in each 8FX flash-/mask-device.

Further, ROM and RAM settings are limited within this project.
Correct these settings within the Linker-Options:

- Softune Workbench
  - Project
    - Setup Poject
      - Linker: Category: Disposition-Connection

        RAM  512 byte: 0x80 - 0x27F
            1024 byte: 0x80 - 0x47F
            2048 byte: 0x80 - 0x87F         <<< CONCERTO-Kit
    
        ROM   16k :  0xC000 - 0xFFFF
              32k :  0x8000 - 0xFFFF
              60k :  0x1000 - 0xFFFF        <<< CONCERTO-Kit
       
Please check the datasheet and hardwaremanual of the related product.