📄 flash_lock_block.c
字号:
//==========================================================================
//
// flash_lock_block.c
//
// Flash programming
//
//==========================================================================
//####COPYRIGHTBEGIN####
//
// -------------------------------------------
// The contents of this file are subject to the Red Hat eCos Public License
// Version 1.1 (the "License"); you may not use this file except in
// compliance with the License. You may obtain a copy of the License at
// http://www.redhat.com/
//
// Software distributed under the License is distributed on an "AS IS"
// basis, WITHOUT WARRANTY OF ANY KIND, either express or implied. See the
// License for the specific language governing rights and limitations under
// the License.
//
// The Original Code is eCos - Embedded Configurable Operating System,
// released September 30, 1998.
//
// The Initial Developer of the Original Code is Red Hat.
// Portions created by Red Hat are
// Copyright (C) 1998, 1999, 2000 Red Hat, Inc.
// All Rights Reserved.
// -------------------------------------------
//
//####COPYRIGHTEND####
//==========================================================================
//#####DESCRIPTIONBEGIN####
//
// Author(s): gthomas
// Contributors: gthomas, msalter
// Date: 2000-09-10
// Purpose:
// Description:
//
//####DESCRIPTIONEND####
//
//==========================================================================
#include "flash.h"
#include <cyg/hal/hal_cache.h>
//
// CAUTION! This code must be copied to RAM before execution. Therefore,
// it must not contain any code which might be position dependent!
//
int
flash_lock_block(volatile unsigned char *block)
{
volatile unsigned char *ROM;
unsigned short stat;
int timeout = 5000000;
int cache_on;
ROM = FLASH_P2V((unsigned long)block & 0xFF800000);
HAL_DCACHE_IS_ENABLED(cache_on);
if (cache_on) {
HAL_DCACHE_SYNC();
HAL_DCACHE_DISABLE();
}
// Clear any error conditions
ROM[0] = FLASH_Clear_Status;
// Set lock bit
FLASH_P2V(block)[0] = FLASH_Set_Lock;
FLASH_P2V(block)[0] = FLASH_Set_Lock_Confirm; // Confirmation
while(((stat = ROM[0]) & FLASH_Status_Ready) != FLASH_Status_Ready) {
if (--timeout == 0) break;
}
// Restore ROM to "normal" mode
ROM[0] = FLASH_Reset;
if (cache_on) {
HAL_DCACHE_ENABLE();
}
return stat;
}
⌨️ 快捷键说明
复制代码
Ctrl + C
搜索代码
Ctrl + F
全屏模式
F11
切换主题
Ctrl + Shift + D
显示快捷键
?
增大字号
Ctrl + =
减小字号
Ctrl + -