📄 flash_unlock_block.c
字号:
//==========================================================================
//
// flash_unlock_block.c
//
// Flash programming
//
//==========================================================================
//####COPYRIGHTBEGIN####
//
// -------------------------------------------
// The contents of this file are subject to the Red Hat eCos Public License
// Version 1.1 (the "License"); you may not use this file except in
// compliance with the License. You may obtain a copy of the License at
// http://www.redhat.com/
//
// Software distributed under the License is distributed on an "AS IS"
// basis, WITHOUT WARRANTY OF ANY KIND, either express or implied. See the
// License for the specific language governing rights and limitations under
// the License.
//
// The Original Code is eCos - Embedded Configurable Operating System,
// released September 30, 1998.
//
// The Initial Developer of the Original Code is Red Hat.
// Portions created by Red Hat are
// Copyright (C) 1998, 1999, 2000 Red Hat, Inc.
// All Rights Reserved.
// -------------------------------------------
//
//####COPYRIGHTEND####
//==========================================================================
//#####DESCRIPTIONBEGIN####
//
// Author(s): lagarwal
// Contributors:
// Date: 2002-03-08
// Purpose:
// Description: contains routine to unlock flash blocks
//
//####DESCRIPTIONEND####
//
//==========================================================================
#include "flash.h"
#include <cyg/hal/hal_cache.h>
extern void printf(char *fmt, ...);
//
// CAUTION! This code must be copied to RAM before execution. Therefore,
// it must not contain any code which might be position dependent!
//
//
// The difficulty with this operation is that the hardware does not support
// unlocking single blocks. However, the logical layer would like this to
// be the case, so this routine emulates it. The hardware can clear all of
// the locks in the device at once. This routine will use that approach and
// then reset the regions which are known to be locked.
//
#define MAX_FLASH_BLOCKS 128
int
flash_unlock_block(volatile unsigned char *block, int block_size, int blocks)
{
volatile unsigned char *ROM, *bp;
unsigned char stat;
int timeout = 5000000;
unsigned char is_locked[MAX_FLASH_BLOCKS];
int i;
#ifdef CYGHWR_IO_FLASH_DEVICE_NOT_IN_RAM
int cache_on;
HAL_DCACHE_IS_ENABLED(cache_on);
if (cache_on) {
HAL_DCACHE_SYNC();
HAL_DCACHE_DISABLE();
}
#endif
ROM = (unsigned char *)FLASH_BASE;
// Clear any error conditions
ROM[0] = FLASH_Clear_Status;
// Get current block lock state. This needs to access each block on
// the device so currently locked blocks can be re-locked.
bp = (unsigned char *)FLASH_BASE;
for (i = 0; i < blocks; i++) {
if (bp == block) {
is_locked[i] = 0;
} else {
bp[0] = FLASH_Read_Query;
is_locked[i] = bp[4];
}
bp += block_size / sizeof(*bp);
}
// Clears all lock bits
block[0] = FLASH_Clear_Locks;
block[0] = FLASH_Clear_Locks_Confirm; // Confirmation
timeout = 5000000;
while(((stat = ROM[0]) & FLASH_Status_Ready) != FLASH_Status_Ready) {
if (--timeout == 0)
{
printf("stat = 0x%02x\n", stat);
goto done;
}
}
// Restore the lock state
bp = (unsigned char *)FLASH_BASE;
for (i = 0; i < blocks; i++) {
if (is_locked[i]) {
bp[0] = FLASH_Set_Lock;
bp[0] = FLASH_Set_Lock_Confirm; // Confirmation
timeout = 5000000;
while(((stat = ROM[0]) & FLASH_Status_Ready) != FLASH_Status_Ready) {
if (--timeout == 0)
{
printf("stat = 0x%02x\n", stat);
goto done;
}
}
}
bp += block_size / sizeof(*bp);
}
done:
// Restore ROM to "normal" mode
ROM[0] = FLASH_Reset;
#ifdef CYGHWR_IO_FLASH_DEVICE_NOT_IN_RAM
if (cache_on) {
HAL_DCACHE_ENABLE();
}
#endif
return stat;
}
⌨️ 快捷键说明
复制代码
Ctrl + C
搜索代码
Ctrl + F
全屏模式
F11
切换主题
Ctrl + Shift + D
显示快捷键
?
增大字号
Ctrl + =
减小字号
Ctrl + -