readme.txt

周立功ARM Stellaris驱动库源程序

DK-LM3S801 Quickstart Application

This example uses the potentiometer on the development board to vary the rate
and frequency of a repetitive beep from the piezo buzzer.  Turning the knob in
one direction will result in slower beeps at lower frequency, while turning it
the other direction will result in faster beeps at a higher frequency.  The
potentiometer setting along with the tone "note" is displayed on the LCD, and a
log of the readings is output on the UART at 115,200, 8-n-1.  The push button
can be used to turn the beeping noise on and off; when off the LCD and UART
still show the setting.

-------------------------------------------------------------------------------

Copyright (c) 2006 Luminary Micro, Inc.  All rights reserved.

Software License Agreement

Luminary Micro, Inc. (LMI) is supplying this software for use solely and
exclusively on LMI's Stellaris Family of microcontroller products.

The software is owned by LMI and/or its suppliers, and is protected under
applicable copyright laws.  All rights are reserved.  Any use in violation of
the foregoing restrictions may subject the user to criminal sanctions under
applicable laws, as well as to civil liability for the breach of the terms and
conditions of this license.

THIS SOFTWARE IS PROVIDED "AS IS".  NO WARRANTIES, WHETHER EXPRESS, IMPLIED OR
STATUTORY, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY
AND FITNESS FOR A PARTICULAR PURPOSE APPLY TO THIS SOFTWARE.  LMI SHALL NOT, IN
ANY CIRCUMSTANCES, BE LIABLE FOR SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES,
FOR ANY REASON WHATSOEVER.

This is part of revision 920 of the Stellaris Driver Library.