c240_cfg.i

jaaj

;=============================================================================
; F240 Clocking configuration file for the Flash utility.
;
; Filename	: C240_CFG.I
; Date		: 26 Feb 97
; Revision	: 1
; Modifications :
;
;
;**** Make selections by changing Underlined options only ****
;				  ~~~~~~~~~~
;
;=============================================================================
YES		.set	1
NO		.set	0

;Select if PLL is enabled or not
;-------------------------------
PLL_ENABLE	.set	YES	; YES: if PLL is used
;			~~~	; NO : if PLL not used & CLKIN of 20MHz is used

;Select PLL multiplication factor (applicable only if PLL_ENABLE set YES)
;------------------------------------------------------------------------
;   Only ONE PLL Mult factor should be selected (set to 1). If more than one is
;   selected only the last on the list will take effect. If none selected then
;   default is PLL MF = 1.0

PLL_MF_10       .set    0       ; 1  : Select PLL Multiply value of 1.0
;			~
PLL_MF_15	.set	0	; 1  : Select PLL Multiply value of 1.5
;			~
PLL_MF_20       .set    1       ; 1  : Select PLL Multiply value of 2.0
;			~
PLL_MF_25	.set	0	; 1  : Select PLL Multiply value of 2.5
;			~
PLL_MF_30	.set	0	; 1  : Select PLL Multiply value of 3.0
;			~
PLL_MF_40	.set	0	; 1  : Select PLL Multiply value of 4.0
;			~
PLL_MF_45	.set	0	; 1  : Select PLL Multiply value of 4.5
;			~
PLL_MF_50	.set	0	; 1  : Select PLL Multiply value of 5.0
;			~
PLL_MF_90	.set	0	; 1  : Select PLL Multiply value of 9.0
;			~

;NOTE: The Flash Programming algorithm assumes an internal cycle time of 50nS
;      (i.e. 20MHz CPU clk) Value selected above should take this in account.