error.dat

s7comm.rar 西门子与pc通讯程序

0000:** ERROR.DAT = error text file for PRODAVE MPI  ** 
00CA:no resources available 
00CE:module not found 
00CF:driver not loaded 
00E1:too many channels open 
00E9:sin_serv.exe not started 
00F1:no global dos storage available 
0101:connection not established / configured 
010A:negative acknowledgement received / timeout error 
010C:data does not exist or disabled 
0201:incorrect interface specified 
0202:maximum amount of interfaces exceeded  
0203:Toolbox already installed 
0204:Toolbox already installed with other connections 
0205:Toolbox not installed 
0206:handle cannot be set 
0207:data segment cannot be disabled 
0209:incorrect data field 
0302:block too small, DW does not exist 
0303:block limit exceeded, correct amount 
0310:module not found 
0311:hardware error 
0312:incorrect configuration parameters 
0313:incorrect baud rate / interrupt vector 
0314:incorrect HSA 
0315:MPI address error 
0316:HW device already allocated 
0317:interrupt not available 
0318:interrupt occupied 
031A:connection error 
0320:hardware error 
0330:version conflict 
0331:COM error 
0332:no response 
0333:COM error 
0334:COM error 
0336:no modem connection established 
0337:job rejected 
0381:device does not exist 
0382:no driver or device found 
0384:no driver or device found 
03FF:system fault 
4001:connection not known 
4002:connection not established 
4003:connection is being established 
4004:connection broken down 
8000:Toolbox occupied 
8001:not allowed in this operating status 
8101:hardware error 
8103:object access not allowed  
8104:context is not supported 
8105:invalid address 
8106:type (data type) not supported 
8107:type (data type) not consistent 
810A:object does not exist  
8301:memory capacity on CPU not sufficient 
8404:grave error 
8500:incorrect PDU size 
8702:address invalid  
D201:syntax error block name 
D202:syntax error function parameter 
D203:syntax error block type 
D204:no linked block in storage medium 
D205:object already exists  
D206:object already exists  
D207:block exists in EPROM 
D209:block does not exist 
D20E:no block available 
D210:block number too big 
D241:protection level of function not sufficient 
D406:information not available  
EF01:incorrect ID2 
FFFE:unknown error FFFE hex 
FFFF:timeout error. Check interface